Numerical Simulation of Extrudate Swell Problem and Evaluation of Applicability of Viscoelastic Constitutive Models : 1. A Study on Axisymmetric Extrudate Swell from a Straight Die
スポンサーリンク
概要
- 論文の詳細を見る
Numerical simulations of axisymmetric extrudate swell for a low density polyethyrene (LDPE IUPAC-A) melt were carried out using the K-BKZ model as an integral type and the PTT and Larson models as a differential type. We employed both the reversible and irreversible models for the K-BKZ and Larson models to investigate the effect of reversing deformation on the extrudate swell from a straight die. First, relaxation spectrum and nonlinear parameters in the constitutive equation were determined from dynamic data of linear viscoelasticity and steady shear flow data by using the nonlinear regression, and then they were applied to the simulation of extrudate swell problem. We evaluated the applicability of these models by comparing experiments and simulation for both rheological data and extrudate swell ratio. For the K-BKZ model, the reversible model over-estimates the swell ratio in high shear rate, whereas the irreversible model predicts the experimental data with high accuracy. The irreversible Larson model also shows the good prediction of swell, on the other hand, the reversible one over-estimates the swell and there exists the multiple solutions. For the PTT model, we carried out the simulation using the models with different values of nonlinear parameter, ε , which has the same steady shear flow properties and the different properties of stress relaxation under reversing double step deformation. The model having the larger stress in the stress relaxation under reversing double step deformation shows the larger swell. From these results, we find that the consideration of reversing deformation characteristics is required for the extrudate swell from the straight die.
- 一般社団法人 日本レオロジー学会の論文
- 2001-03-01
著者
-
KAJIWARA Toshihisa
Department of Chemical Engineering, Faculty of Engineering, Kyushu University
-
Kajiwara Toshihisa
Department Of Chemical Engineering Faculty Of Engineering Kyushu University
-
Kajiwara Toshihisa
Department Of Materials Science Kyushu Institute Of Technology
-
TOMIYAMA Hideki
Department of Materials Science, Kyushu Institute of Technology
-
SUEYOSHI Yumi
Department of Materials Science, Kyushu Institute of Technology
-
YAMAMURA Masato
Department of Materials Science, Kyushu Institute of Technology
-
ADACHI Kitaro
Department of Materials Science, Kyushu Institute of Technology
-
Yamamura Masato
Department Of Applied Chemistry Kyushu Institute Of Technology
-
Yamamura Masato
Department Of Materials Science Kyushu Institute Of Technology
-
Tomiyama Hideki
Department Of Materials Science Kyushu Institute Of Technology
-
Adachi Kitaro
Department Of Materials Science Kyushu Institute Of Technology
-
Sueyoshi Yumi
Department Of Materials Science Kyushu Institute Of Technology
関連論文
- Three-dimensional viscoelastic analysis of multi-layer polymer flow by numerical simulation (計算機レオロジー特集号)
- Preparation of SiO2–PVA nanocomposite and monolithic transparent silica glass by sintering
- Evaluation of a bioreactor with stacked sheet shaped organoids of primary hepatocytes(CELL AND TISSUE ENGINEERING)
- Hepatic Differentiation of Mouse Embryonic Stem Cells in a Three-Dimensional Culture System Using Polyurethane Foam(CELL AND TISSUE ENGINEERING)
- Evaluation of instability after transtrochanteric anterior rotational osteotomy for nontraumatic osteonecrosis of the femoral head
- Development of a Hybrid Artificial Liver Based on Hepatocyte Organoid Culture Technique for Chronic Liver Failure Patients
- Numerical Simulation of Extrudate Swell Problem and Evaluation of Applicability of Viscoelastic Constitutive Models : 1. A Study on Axisymmetric Extrudate Swell from a Straight Die
- Suppressed Cracking in Drying Nanoparticle-Polymer Coatings at High Peclet Numbers
- Nonuniform Thinning of Polymeric Coatings under Marangoni Stress
- Drying-Rate Limit in Condenser Drying of Thin Film Coatings
- Noncontact measurement of viscosity of B2O3 melt using electric-field tweezers (ナノ/マイクロレオロジー特集号)
- Afterglow luminance property of phosphorescent phosphor SrAl2O4:Eu2+,Dy3+-glass composites
- Reconstruction of Cartilage Tissue Using Scaffold-Free Organoid Culture Technique(CELL AND TISSUE ENGINEERING)
- Relationship between Neck-in Phenomena and Rheological Properties in Film Casting (工業レオロジー特集号)
- Antimicrobial effect of porcelain glaze with silver-clay antimicrobial agent
- Relationship between Neck-in Phenomena and Rheological Properties in Film Casting (工業レオロジー特集号)
- Enhanced Solvent Drying of Liquid Film Coatings by Fluorine-Base Polymeric Surfactant Addition
- Noncontact measurement of viscosity of B2O3 melt using electric-field tweezers (ナノ/マイクロレオロジー特集号)
- Wetting-Induced Entrapment of a Droplet in a UV-Curable Volatile Liquid Coating
- Stress Oscillations in Co-Solvent Nanoparticle–Polymer Suspensions Subjected to Constant Shear Rate
- Capturing the Efficiency of a Melt-Mixing Process for Polymer Processing