加工穴を利用した微細放電加工法の研究
スポンサーリンク
概要
- 論文の詳細を見る
This paper proposes a new micro electrical discharge machining method which can machine micro rods and holes quick and cheap without a special equipment. With this method, a rod electrode with negative polarity is rotated and fed into a plate electrode to form a hole. After the rod electrode returns to the initial position, the axis of the rod electrode is off-centered from the center of the hole at a certain distance. The polarity of the rod electrode is then reversed, and the rod electrode is fed into the plate electrode, either with or without rotation. Since holes are formed by the rod electrode itself, the rod electrode can be machined very precisely. Since this method does not need initial positioning of the tool electrode with respect to the plate electrode, the operation is easy and short. However, a straight and long rod electrode is difficult to be formed because of the plate electrode wear. Moreover, when the axis of the rod electrode does not coincide with the axis of rotation, the rod electrode cannot be machined precisely. Thus the two step method, run-out measuring method, and dummy hole diameter measuring method were newly proposed to obtain more improvement of accuracy. High accuracy axis was formed using these methods even when the rod electrode does not coincide with the axis of rotation.
- 公益社団法人精密工学会の論文
- 2006-05-05
著者
-
国枝 正典
東京農工大
-
山崎 実
東京都立産業技術研究センター
-
鈴木 岳美
東京都立産業技術研究センター
-
森 紀年
東京都立産業技術研究センター
-
森 紀年
(財)東京都中小企業振興公社 城東振興センター
-
国枝 正典
東京農工大学大学院機械システム工学専攻
-
山崎 実
東京都立産業技術研究所
関連論文
- ワイヤ放電加工中のワイヤ電極に作用する電磁力の影響
- 局所電界重畳による放電加工の放電位置制御
- 超砥粒砥石の気中放電ドレッシング : 第2報 : 微細砥粒砥石への適用
- 拡散接合による微細噴流穴付き放電加工総形電極の製作
- 分光分析による放電加工アークプラズマの温度測定
- 327 形彫り放電加工の放電点分布シミュレーション(OS1 金型の製作,放電加工)
- 放電点探索式放電加工シミュレーションの精度向上
- 電解液ジェット加工によるディンプルソーワイヤの製作
- 超硬合金における気中創成加工に関する研究
- C36 シリコンウェーハの異方性が形状測定に与える影響(OS-5 加工計測・評価)