Dynamic Contact Angles of Water Droplets Sliding on Inclined Hot Surfaces
スポンサーリンク
概要
- 論文の詳細を見る
A water droplet was slid on an inclined plate whose lower surface was kept at a temperature between room temperature and 510 K. The dependence of the dynamic advancing and receding contact angles on the wall temperature and the contact line velocity was measured from the shape of the droplet sliding on the high temperature surface. The experimental results demonstrate that a rise in the wall temperature increases the dynamic contact angles due to evaporation from the meniscus. The dynamic receding contact angles at high temperatures increase with increasing the receding velocity of the contact line. This result is contrary to the well-known fact at room temperature. The velocity dependence of the dynamic advancing contact angle is similar to the well-known dependence at room temperature.
- 社団法人 化学工学会の論文
著者
-
深井 潤
九州大学大学院 工学研究院 化学工学部門
-
Fukai Jun
Department Of Chemical Engineering Graduate School Of Engineering Kyushu University
-
MIYATAKE Osamu
Department of Chemical Systems and Engineering, Kyushu University
-
Miyatake Osamu
Department Of Chemical Engineering Kyushu University
-
Miyatake Osamu
Department Of Chemical Systems And Engineering Kyushu University
-
ETOU Masaharu
Department of Chemical Systems and Engineering, Kyushu University
-
ASANOMA Fumio
Department of Chemical Systems and Engineering, Kyushu University
-
Asanoma Fumio
Department Of Chemical Systems And Engineering Kyushu University
-
Etou Masaharu
Department Of Chemical Systems And Engineering Kyushu University
-
Fukai Jun
Department Of Chemical Engineering Graduate Of School Kyushu University
関連論文
- 畜産廃棄物発電システムにおける流動床炉フリーボード部内の燃焼ガス温度
- チューブ式熱交換器における交換可能な伝熱促進フィンの研究(熱工学,内燃機関,動力など)
- 非定常短細線熱伝導セル内の短細線周りの自然対流の数値シミュレーション
- 飲料缶の抵抗シーム溶接性に及ぼす差厚薄スズめっきの影響
- 抵抗シーム溶接性に及ぼす通電領域の影響
- 飲料缶の抵抗シーム溶接性と等価的接触抵抗の関係
- インクジェット製膜法における2成分溶媒の効果
- インクジェット法によるフルオロアルキルシラン単分子膜パターン基板への位置選択的な高分子薄膜の形成
- 研究室紹介
- インクジェット法による高分子薄膜形成の移動現象
- 粒子充填層内の伝熱速度に及ぼすカーボンナノチューブの影響
- 炭素繊維クロスにより伝熱面を拡大した潜熱蓄熱槽の性能
- 炭素繊維クロスを利用した潜熱蓄熱槽の開発
- 6-211 化学工学教育における創成型科目((7)ものつくり教育-V)
- 炭素繊維を用いた熱エネルギー利用機器の伝熱促進
- 炭素繊維を用いた熱エネルギー利用機器の伝熱促進 (特集:熱エネルギー変換・貯蔵材料)
- インクジェット法による薄膜形成の移動現象 : 蒸発速度と溶質濃度の影響
- 306 熱利用機器における粒子充填層反応器内の反応速度の促進(OS3-2,OS3 多孔質体内流動・伝熱・燃焼研究の新展開)
- インクジェット成膜における蒸発液滴の挙動(オーガナイズドセッション4 材料創成プロセスと熱工学)
- 炭素繊維クロスを用いた潜熱蓄熱槽の性能予測(オーガナイズドセッション3 蓄冷・蓄熱および熱輸送機器)
- 熱工学
- 炭素繊維ブラシを利用した潜熱蓄熱槽の性能試験
- 多管式潜熱蓄熱槽性能評価のための簡易数値シミュレーションモデル
- 2液滴衝突によるガス吸収促進に関する数値解析
- Transport Phenomena in a Packed Bed Reactor of Metal Hydride and Promotion of Its Reaction Rates by Heat Transfer Enhancement
- D210 炭素繊維ブラシが伝熱管周りの熱伝導に及ぼす影響(オーガナイズドセッション14 : 固・液相変化を伴う熱・物質移動及び流動の基礎と応用)
- Maximum Spreading of Liquid Droplets Colliding with Flat Surfaces
- Growth and structures of surface disturbances of a round liquid jet in a coaxial airflow
- Site-selective Coating of Polymer Thin Film Prepared by the Ink-jet Method on the Patterned Fluoroalkylsilane Monolayer Substrate
- Oscillation of a tilted circular pad on a droplet for the self-alignment process
- Solute Deposit during Evaporation of a Sessile Binary Liquid Micro-Droplet on a Substrate
- A12-084 SOLUTE DEPOSIT DURING EVAPORATION OF BINARY LIQUID MICRO-DROPLET ON A SUBSTRATE
- 壁面に衝突した液滴の伝熱現象の数値解析
- D243 2 液滴衝突時における高シュミット数物質移動の数値解析
- B151 平板に衝突した液滴の見かけ接触角の速度依存性
- 炭素繊維/パラフィン複合材を用いたカプセル型蓄熱装置の放熱特性
- 同軸周囲気流を伴う円管液体噴流の変動および液滴生成特性
- 同軸周囲気流中における液体噴流のスペクトル特性
- 419 炭素繊維を熱伝導度促進体として用いた潜熱蓄熱槽の開発(OS.1-2)(オーガナイズドセッション : 熱エネルギーの高効率利用)
- スパイラル炭素繊維による粒子充填層反応器内の伝熱促進
- 畜糞を燃料とした流動床式燃焼炉内の燃焼特性
- 畜産廃棄物発電システムにおける流動床燃焼炉内の燃焼特性
- 壁面に衝突した溶融金属滴の凝固速度に及ぼす操作条件の影響
- Effect of Pellet Size on Discharge Characteristics of Latent Heat Storage Columns Packed With Cross-Linked Polymer Pellets
- Transient Characteristics and Performance of Hybrid Latent Heat Storage and Spray Flash Evaporation System
- THREE-DIMENSIONAL NUMERICAL SIMULATION OF HEAT CONDUCTION IN A SHORT-HOT-WIRE THERMAL CONDUCTIVITY MEASUREMENT CELL
- 乾留過程における炭素材料内伝熱現象のモデル化
- Specific Behaviors of Polymer Solution Droplets on Surfaces due to Solutal Marangoni Effect
- Thermal Stratification Phenomena in a Tower-Style Tank for Simultaneous Storing of Warm and Ice
- 低温排熱有効活用のための水蒸気回生ヒートポンプシステムの開発 : 基本概念と省エネルギー効果の予測
- Dynamic Contact Angles of Water Droplets Sliding on Inclined Hot Surfaces
- Numerical Simulation of Liquid Droplet Solidification on Substrates
- 熱物性研究をしていない学会員
- Marangoni Flows in Polymer Solution Droplets Drying on Heating Surfaces
- Self-Organization of Polymer Films Using Single and Mixed Solvents on Chemically Patterned Surfaces
- Numerical Simulation for Steam Generation Process in a Novel Zeolite-Water Adsorption Heat Pump
- Experimental Investigation on the Adsorption Process for Steam Generation Using a Zeolite-Water System
- Factors Dominating Polymer Film Morphology Formed from Droplets Using Mixed Solvents
- Self-Organization of Polymer Films Using Single and Mixed Solvents on Chemically Patterned Surfaces
- Numerical Simulation for Steam Generation Process in a Novel Zeolite–Water Adsorption Heat Pump
- 平板に接触した二元合金薄片の1次元非平衡凝固モデル
- Experimental Investigation on the Adsorption Process for Steam Generation Using a Zeolite–Water System
- Marangoni Flows in Polymer Solution Droplets Drying on Heating Surfaces
- Numerical Study on Pulverized Biochar Injection in Blast Furnace