Welding Thin Pt Wires with Dissimilar Diameters by Joule Heating

スポンサーリンク

概要

• 論文の詳細を見る

• In this paper, the Joule heat welding of thin Pt wires with different diameters was performed and the current required for successful welding was investigated. The diameter of one wire was 800 nm and the others had various diameters of 1, 2, and 5 μm. Various combinations of wire lengths were used in the welding experiments. The minimum and maximum currents for successful welding were found to be highly dependent on the length of the 800 nm diameter wire. From these experimental results, it was inferred that the highest temperature in the system during welding occurred in some part of the 800 nm diameter wire and that the temperature in the larger diameter wire with sufficient heat capacity were almost unchanged. It was also found that the conditions for successfully welding wires of different diameter can be described by a parameter previously proposed for classifying the successful conditions for welding two 800 nm diameter wires.

• 2013-06-25

著者

• Tohmyoh Hironori

  Department Of Mechanical Engineering Tohoku University

• Fujimori Masato

  Department Of Chemistry Graduate School Of Science Nagoya University

• Fujimori Masato

  Department of Nanomechanics, Tohoku University, Sendai 980-8579, Japan

関連論文

• Checking Surface Contamination and Determination of Electrical Resistivity of Oxide Scale Deposited on Low Carbon Steel by DC Potential Drop Method
• Multi-Dimensional Crystal Structures and Unique Solid-State Properties of Heterocyclic Thiazyl Radicals and Related Materials
• Measurement of Potential Drop Distribution by Scanning the Closely Coupled Probes Sensor for Sensitive NDE of Shallow Surface Cracks
• The Effect of Surgical Treatment of Obstructive Sleep Apnea Syndrome on the Plasma TNF-α Levels
• Effective Transmission of High Frequency Ultrasound into a Silicon Chip through a Polymer Layer(Advanced Technology of Experimental Mechanics)
• Determination of Friction Coefficient of a Press-Fit Pin in Thin Plating(Macro-, Micro-, Meso-, and Nano-scopic Strength of Materials Relating to Microstructures)
• Mechanical Properties of Thin Al Wires Prepared by Electromigration
• Welding Thin Pt Wires with Dissimilar Diameters by Joule Heating
• Evaluation of Electrical Resistivity of Oxide Scale Formed under Different Conditions

スポンサーリンク