Generation of circumferential guided waves using a bulk shear wave sensor and their mode identification
スポンサーリンク
概要
- 論文の詳細を見る
A novel method of generating circumferential guided waves (C-GWs) propagating in a pipe has been proposed using a single bulk shear wave (BSW) sensor. The generated C-GWs are classified into circumferential shear horizontal (C-SH) waves and circumferential Lamb (C-Lamb) waves. The BSW sensor is dry-coupled on the outer surface of the pipe to generate the C-GWs. The selective generation of the C-SH wave or the C-Lamb wave was realized by changing the polarization direction of the BSW sensor relative to the axial direction of the pipe. The C-SH and C-Lamb waves were selectively generated using a 66-mm-outer-diameter and 0.1-mm-thick steel pipe, and a 30-mm-outer-diameter and a 1-mm-thick aluminum (Al) pipe, respectively. The obtained results were compared with both theoretical group velocities and particle displacements to identify the specific propagation mode. The group velocities of the generated C-GWs were in good agreement with the theoretical values. The generation efficiency of the C-GWs was also discussed on the basis of the theoretical particle displacements for their modes.
- Published by the Japan Society of Applied Physics through the Institute of Pure and Applied Physicsの論文
- 2007-07-30
著者
-
Nishino Hideo
Institute Of Science And Technology The University Of Tokushima
-
Yoshida Kenichi
Institute Of Science And Technology The University Of Tokushima
-
Nishino Hideo
Institute of Science and Technology, The University of Tokushima, Tokushima 770-8506, Japan
-
Yokoyama Ryuji
Institute of Science and Technology, The University of Tokushima, Tokushima 770-8506, Japan
-
Kondo Hironori
Institute of Science and Technology, The University of Tokushima, Tokushima 770-8506, Japan
-
NISHINO Hideo
Institute of Engineering and Science, The University of Tokushima
-
Yoshida Kenichi
Institute of Science and Technology, The University of Tokushima, Tokushima 770-8506, Japan
-
YOSHIDA Kenichi
Institute of Engineering and Science, The University of Tokushima
関連論文
- Theoretical and Experimental Investigations of Transmission Coefficients of Longitudinal Waves through Metal Plates Immersed in Air for Uses of Air Coupled Ultrasounds
- Experimental Investigation of Mode Conversions of the $\mathrm{T}(0,1)$ Mode Guided Wave Propagating in an Elbow Pipe
- Precise measurement of pipe wall thickness in noncontact manner using a circumferential lamb wave generated and detected by a pair of air-coupled transducers (Special issue: Ultrasonic electronics)
- Simple method of generating for circumferential shear horizontal waves in a pipe and their mode identifications(introduction to the amazing world of sounds with demonstrations)
- Long-Range Testing of Welded Elbow Pipe Using the $\mathrm{T}(0,1)$ Mode Ultrasonic Guided Wave
- Tone-Burst Generation of Circumferential Guided Waves by a Bulk Shear Wave Sensor and Their Wide-Range Time–Frequency Analyses
- Highly Sensitive Detection of Defects in Piping Using Multireflecting Guided Wave Energy Trapping Method
- Generation of circumferential guided waves using a bulk shear wave sensor and their mode identification
- Efficient Generation and Detection of a Guided Wave in a Pipe using Guided Wave Reflectors
- Defect Detection of a Pipe Using a Guided Wave Generated by an Efficient Transduction with a Reflector