Effect of ZnS Adhesion Layer on Overwrite Cyclability of Phase Change Optical Recording Media
スポンサーリンク
概要
- 論文の詳細を見る
A high-performance phase change optical recording disk, which has a five-layered structure, was proposed. This disk has a ZnS adhesion layer between a GeSbTe recording layer and a ZnS–SiO2 second dielectric layer. A $2\times 10^{5}$ overwrite cyclability was achieved with the original five-layered phase change optical recording disk. The cross-sectional transmission electron microscope observation and the in-plane X-ray diffraction measurement indicate that both the five-layered disk and the four-layered disk have almost the same crystalline structure. The contact angle measurements, however, indicate that the ZnS adhesion layer improves the adhesive force between the GeSbTe recording layer and the ZnS–SiO2 second dielectric layer. It is considered that the high overwrite cyclability results from this improvement of the adhesive force. Moreover, the electron probe microanalysis results indicate that the ZnS layer acts as a protective layer against the Ge diffusion from the GeSbTe recording layer.
- Publication Office, Japanese Journal of Applied Physics, Faculty of Science, University of Tokyoの論文
- 2001-03-30
著者
-
Takase Aya
Application Laboratory Rigaku Corporation
-
Fujinawa Go
Application Laboratory Rigaku Corporation
-
Sugiyama Ikuto
Recording Media Division Teijin Limited
-
Hirasaka Masao
Polymer Research Center Teijin Limited
-
Sugiyama Ikuto
Recording Media Research Laboratory, Teijin Limited, 1-1-1 Enichi-cho, Mihara-shi, Hiroshima 723-8611, Japan
-
Ebina Atsushi
Recording Media Research Laboratory, Teijin Limited, 1-1-1 Enichi-cho, Mihara-shi, Hiroshima 723-8611, Japan
-
Isemoto Jun
Material Analysis Research Laboratory, Teijin Limited, 4-3-2 Asahigaoka, Hino-shi, Tokyo 191-8512, Japan
-
Hirasaka Masao
Polymer Research Center, Teijin Limited, 2-1-1 Uchisaiwai-cho, Chiyoda-ku, Tokyo 100-8585, Japan
関連論文
- Structural Phase Transition from Rhombohedral to Cubic in LaCoO_3
- UV Laser Mastering with a Multilayer Coating Method Producing Land/Groove Type of Optical Disk with Track Pitch of 0.3 μm or Less
- High-Density Optical Disk Mastering Using Multilayer Coating Method
- Crystal Structure of Oxygen/Nitrogen-Doped GeSbTe Phase-Change Media : Investigation Using Grazing Incidence X-ray Diffraction (Short Note)
- Improvements of Resolution and Surface Roughness using Alkaline Treatment of Photoresist Surface in High-Density Optical Disk Mastering
- Effect of ZnS Adhesion Layer on Overwrite Cyclability of Phase Change Optical Recording Media