Macro Characteristics and Internal Structures of High Pressure Injection DME Spray
スポンサーリンク
概要
- 論文の詳細を見る
The injection pressure of conventional DME engine is lower than 60MPa, because bulk modulus of DME is low. In order to obtain new insights into the performance improvement of the DME engine, DME spray characteristics under high injection pressure up to 140MPa are examined in the condition equal with the engine(4.5MPa-800K), Internal structures of DME spray were analyzed by using the computational code KIVA-3V. Results showed that the macro characteristics of DME spray was almost the same as diesel fuel spray. An increase in fuel injection pressure would boost spray development while the vaporization distance did not change because vaporization was enhanced at the same time. The air entrainment of the spray was increased and overall equivalence ratio in the spray was lowered with higher the injection pressure.
- 公益社団法人 自動車技術会の論文
公益社団法人 自動車技術会 | 論文
- 歩行者検出のためのミリ波レーダの注視制御
- Analysis of Vehicle Dynamics to Steering Wheel Torque on the On-center
- ＬＰＧ燃料ポンプシステムのスライディングモード制御
- In-vehicle Effect Measurement for a System to Prevent Dangerous Driving
- モデルベース制御のためのディーゼルエンジン構成要素のモデリング―吸気系モデルの構築と予測精度の検証―:—吸気系モデルの構築と予測精度の検証—