過大荷重を負荷した試験片の疲労き裂進展加速の機構
スポンサーリンク
概要
- 論文の詳細を見る
The acceleration mechanism of crack growth after applying overload was investigated under baseline stress ratio R = -1. An overload was applied during fatigue crack growth test with constant stress amplitude by using carbon steel. Not only the overload level but also the cyclic stress condition affected the crack growth behavior after overloading. The effects of an overload on the rate of fatigue crack growth at constant amplitude have been of interest for some time, and much information has been gathered through which the crack growth was retarded. However there is relatively little information concerning the effects of an overload through which the crack growth was accelerated. Where the cyclic stress level was higher, the crack growth rate after overloading was kept higher level depending on the experimental conditions. Also, the acceleration of the crack growth was observed in some testing under plane stress conditions. Where the acceleration of crack growth was observed, the crack tips were blunted by applying overload. Thus the conditions of tensile overload affected zone were related to the acceleration of crack growth. It is discussed from the experimental results that the crack growth acceleration after overload was caused by the tensile residual stress developed in front of the crack tips due to applying compressive cyclic stress of which value exceeded a critical level.
- 日本材料学会の論文
著者
-
真壁 朝敏
琉球大学工学部機械システム工学科
-
山内 章広
沖縄県工業技術センター
-
真壁 朝敏
琉球大学工
-
宮崎 達二郎
琉球大学工
-
宮原 永
三重金属工業(株)
-
宮原 永
三重金属工業(株)
-
宮崎 達二郎
琉球大学工学部機械システム工学科
関連論文
- ストップホールおよび付加円孔の寸法,位置が疲労寿命延命効果に及ぼす影響
- ゴムの二軸引張り試験における公称応力・ひずみの簡易計算法
- アルミニウム鋳造合金における疲労特性のメゾスケール特性からの評価 : 第2報,応力比-1下での複数種の異材粒子を含む金属の平滑材における疲労限度信頼性の予測
- 有限板の円孔から発生した非対称き裂および有限板に発生した非対称き裂の引張りにおける応力拡大係数について
- 引張りを受ける有限板の中央切欠きから発生したき裂の応力拡大係数について
- 単一過大荷重を負荷した鋭い切欠きを有する試験片から発生するき裂の進展評価
- 有限板中の中央2重U字切欠きから発生したき裂の引張りにおける応力拡大係数について
- ねじり予ひずみ材の破断延性低下について
- 疲労き裂伝ぱ過程における過大荷重負荷履歴の検知手法
- インコネル合金のフレッティング疲労特性とき裂発生検出