Microstructure and Mechanical Properties of JLF-1 and CLAM Steels Exposed to Thermal Aging with Stress
スポンサーリンク
概要
- 論文の詳細を見る
In this work, effects of low levels of stress during aging at 823 and 973 K for 100 h on mechanical properties and microstructures were investigated for JLF-1 and CLAM steels. The results showed that hardness decreased and tensile strength increased after aging at 823 K for 100 h with stresses from 9 to 100 MPa for the both steels. The improvement of tensile properties was due to increase in number density of precipitates, especially with small size. On the contrary, hardness, tensile and creep strength decreased after aging at 973 K for 100 h, suggesting softening. The degradation of these properties was accelerated by applying stresses of 30 and 50 MPa during the aging. Decrease in number density of precipitates, partial recovery of martensitic structures and coarsening of lath width, were responsible for the degradation of mechanical properties at 973 K for 100 h and under applied stress.
- 社団法人 プラズマ・核融合学会の論文
著者
-
NAGASAKA Takuya
National Institute for Fusion Science
-
MUROGA Takeo
National Institute for Fusion Science
-
LI Yanfen
National Institute for Fusion Science, 322-6 Oroshi-cho, Toki 509-5292, Japan
-
MUROGA Takeo
National Institute for Fusion Science, 322-6 Oroshi-cho, Toki 509-5292, Japan
-
NAGASAKA Takuya
National Institute for Fusion Science, 322-6 Oroshi-cho, Toki 509-5292, Japan
関連論文
- Recovery of Hardness, Impact Properties and Microstructure of Neutron-Irradiated Weld Joint of a Fusion Candidate Vanadium Alloy
- Fracture Toughness of JLF-1 by Miniaturized 3-Point Bend Specimens with 3.3-7.0mm Thickness
- Deuterium Retention of Vanadium Alloy, V-4Cr-4Ti
- Surface Segregation of Ti in a V-4Cr-4Ti Alloy and Its Influence on the Surface Reaction Rates of Hydrogen Isotopes
- ICONE11-36288 OPTICAL MEASUREMENT OF WAVES ON HIGH-SPEED LITHIUM JET SIMULATING IFMIF TARGET FLOW
- Mechanical Properties of a High-Purity Fe-9Cr-2W-0.1C Model Alloy for Low-Activation Ferritic Steels for Fusion Reactors
- Liquid Metal Lithium Jet Experiment for IFMIF Target
- Interstitial Diffusion of C Interacting with Ambient H in Tungsten Crystals
- Characterization of Ion Cyclotron Wall Conditioning Using Material Probes in LHD
- Sintering Behavior of Metal Powders Involving Microwave-Enhanced Chemical Reaction
- Long-Term Thermal Stability of Reduced Activation Ferritic/Martensitic Steels as Structural Materials of Fusion Blanket
- Microstructure of Oxide Insulator Coating before and after Thermal Cycling Test
- Neutronics and Activation Analyses for Li/V-alloy and Flibe/V-alloy Blankets of FFHR2 with and without Beryllium
- Microstructure and Mechanical Properties of JLF-1 and CLAM Steels Exposed to Thermal Aging with Stress
- Corrosion Characteristics of Hydrogen Permeation Materials in Molten Salt Flinak
- Irradiation Creep Behavior of Vanadium Alloys during Neutron Irradiation in a Liquid Metal Environment
- Evaluation of Adhesion Strength of Er2O3 Coating Layer for an Advanced Breeding Blanket System Applied to Thermal Cycles using Nano-Scratch Method
- Irradiation Effect on Tensile Property of F82H IEA and Its Joint in TITAN Project