Long-Term Thermal Stability of Reduced Activation Ferritic/Martensitic Steels as Structural Materials of Fusion Blanket
スポンサーリンク
概要
- 論文の詳細を見る
In this work, the effects of thermal ageing on mechanical properties of JLF-1 and CLAM steels have been studied at temperatures in a range of 823-973 K. The results showed that the hardness increased slightly and the creep properties improved after ageing at 823 K for 2000 h for the both steels. On the other hand, the hardness decreased after ageing above 823 K, especially at 973 K for 100 h, and the creep property degraded at 973 K for 100 h. The Larson-Miller parameter was used for predicting the long-term creep performance based on the short-term experiments at higher temperature with higher stress including the pre-ageing effects. By extrapolation to the typical blanket condition, 823 K for 100 000 h, the rupture stress was estimated to be about 140 MPa for the both steels. The present thermal ageing treatments influence the estimated rupture stress for about ±10 MPa for both steels.
- 社団法人 プラズマ・核融合学会の論文
著者
-
NAGASAKA Takuya
National Institute for Fusion Science
-
MUROGA Takeo
National Institute for Fusion Science
-
LI Yanfen
The Graduate University for Advanced Studies, 322-6 Oroshi, Toki, Gifu 509-5292, JAPAN
関連論文
- Recovery of Hardness, Impact Properties and Microstructure of Neutron-Irradiated Weld Joint of a Fusion Candidate Vanadium Alloy
- Fracture Toughness of JLF-1 by Miniaturized 3-Point Bend Specimens with 3.3-7.0mm Thickness
- Deuterium Retention of Vanadium Alloy, V-4Cr-4Ti
- Surface Segregation of Ti in a V-4Cr-4Ti Alloy and Its Influence on the Surface Reaction Rates of Hydrogen Isotopes
- ICONE11-36288 OPTICAL MEASUREMENT OF WAVES ON HIGH-SPEED LITHIUM JET SIMULATING IFMIF TARGET FLOW
- Mechanical Properties of a High-Purity Fe-9Cr-2W-0.1C Model Alloy for Low-Activation Ferritic Steels for Fusion Reactors
- Liquid Metal Lithium Jet Experiment for IFMIF Target
- Interstitial Diffusion of C Interacting with Ambient H in Tungsten Crystals
- Characterization of Ion Cyclotron Wall Conditioning Using Material Probes in LHD
- Sintering Behavior of Metal Powders Involving Microwave-Enhanced Chemical Reaction
- Long-Term Thermal Stability of Reduced Activation Ferritic/Martensitic Steels as Structural Materials of Fusion Blanket
- Microstructure of Oxide Insulator Coating before and after Thermal Cycling Test
- Neutronics and Activation Analyses for Li/V-alloy and Flibe/V-alloy Blankets of FFHR2 with and without Beryllium
- Microstructure and Mechanical Properties of JLF-1 and CLAM Steels Exposed to Thermal Aging with Stress
- Corrosion Characteristics of Hydrogen Permeation Materials in Molten Salt Flinak
- Irradiation Creep Behavior of Vanadium Alloys during Neutron Irradiation in a Liquid Metal Environment
- Evaluation of Adhesion Strength of Er2O3 Coating Layer for an Advanced Breeding Blanket System Applied to Thermal Cycles using Nano-Scratch Method
- Irradiation Effect on Tensile Property of F82H IEA and Its Joint in TITAN Project