UVおよびTiO2を用いたABS樹脂の改質効果

概要

論文の詳細を見る
ABS resin has been widely applied as a plating substrate for plastics in applications such as the parts of vehicles and electrical devices. Hexavalent chromium has been applied as an etchant of plating on ABS resin. However, it is required to eliminate hexavalent chromium from the pretreatment process, since the prohibition of these treatments was determined by the EU directive on the End of Life Vehicles (ELV) from July, 2007. Therefore, alternative etching without hexavalent chromium has been investigated by using ultra violet irradiation (UV) and titanium oxide (TiO2) as a photocatalyst. We already achieved adhesion with the strength of about 1.0kNm−1 between ABS resin and deposited metal without hexavalent chromic acid etching. In this study, the mechanism of adhesion strength improvement with photocatalysts has been investigated using ABS specimens and rubber related ABS resin. As the results, the 1,2-polybutadiene distributed in the AS matrix was preferentially reformed and induced hydrophilicity on the reformed surface with the remaining network structure by cross-linking. In addition, we found that the reformed layer was composed a few μm thick and the catalyst penetrated into 30-40nm from the surface. It was concluded that the good adhesion strength between the deposited metal and resin was derived from the nano-anchor effect by the deposition of metal from the inside of 30-40nm of reformed resin.