Effect of Reaction Temperature and Sonication Pretreatment in the Hydrothermal Process on the Morphology of Titanate Nano-Structure
スポンサーリンク
概要
- 論文の詳細を見る
Titanate nanostructures were synthesized by hydrothermal technique. The sonication pretreatment and reaction temperature were employed to investigate the morphology and specific surface area of the titanate nanostructure. Transmission electron microscopy, dynamic light scattering, and nitrogen adsorption were used to characterize and elucidate the behavior of titanate nanostructures in each experimental condition. By the effect of sonication pretreatment, the length and BET surface area of titanate nanotubes (TNTs) were raised from 50 nm to 490–1760 nm and from 180 to 260 m2 g–1, respectively, because of de-agglomeration of TiO2 particles in the precursor. The BET surface area of TNTs increased with increasing hydrothermal temperature from 90 to 150°C However, when the reaction temperature increased up to 180°C, BET surface area of TNTs inversely decreased. The reason of the decline in surface area could be explained by morphology of titanate formed. The nanotube structure (hollow) of titanate was transformed to nanofiber structure (non-hollow) at this high temperature.
著者
-
TANTHAPANICHAKOON Wiwut
National Nanotechnology Center
-
Sano Noriaki
Department Of Chemical Engineering Faculty Of Engineering Himeji Institute Of Technology
-
Faungnawakij Kajornsak
National Nanotechnology Center National Science And Technology Development Agency
-
Charinpanitkul Tawatchai
Center of Excellence in Particle Technology (CEPT), Department of Chemical Engineering, Chulalongkorn University
-
Viriya-Empikul Nawin
National Nanotechnology Center, National Science and Technology Development Agency (NSTDA)
-
Soottitantawat Apinan
Center of Excellence in Particle Technology (CEPT), Department of Chemical Engineering, Chulalongkorn University
-
Kikuchi Takeyuki
Department of Engineering Science, University of Hyogo
-
Tanthapanichakoon Wiwut
National Nanotechnology Center, National Science and Technology Development Agency (NSTDA)
-
Faungnawakij Kajornsak
National Nanotechnology Center, National Science and Technology Development Agency (NSTDA)
関連論文
- Influence of Electric Field Strength in a High-Temperature Corona Discharge Reactor on Removal of Toluene from Nitrogen and Air
- Effect of Structure of Corona-Discharge Reactor on Removal of Dilute Gaseous Pollutants Using Selective Electron Attachment
- REMOVAL OF IODINE AND METHYL IODIDE IN GAS BY WETTED-WALL REACTOR BASED ON SELECTIVE ELECTRON ATTACHMENT
- Effect of Supercritical Water Treatment on Porous Structure, Liquid-Phase Adsorption and Regeneration Characteristics of Activated Anthracite
- Removal of Trimethylamine in Gas by Corona-Discharge Reactor
- Decomposition of Phenol in Water by Ozone Oxidation with Metal-Supported Carbongel
- Review of Recent Research on Nanoparticle Production in Thailand
- Formation of strontium-doped lanthanum manganite (La_Sr_MnO_3) by mechanical milling without media balls
- Simultaneous Gas-Water Purification by a Wetted-Wall Corona Discharge Reactor : Decomposition of Aqueous Phenol and Gaseous Acetaldehyde
- Effect of Reaction Temperature and Sonication Pretreatment in the Hydrothermal Process on the Morphology of Titanate Nano-Structure
- Formation of Crystal Film at Interface in Process of Extraction of Rare Earth Metals by D2EHPA
- Gas sensor using single-wall carbon nanohorns
- Characterization of Adsorption Properties of H_2O on Si(001) and Si(111) by Ellipsometry and ab initio Molecular Orbital Calculations
- Decomposition of Aqueous Phenol by Direct Contact of Gas Corona Discharge with Water : The Influence of Current Density and Applied Voltage
- Degradation of Phenol in Aqueous Solution by TiO_2 Photocatalyst Coated Rotating-Drum Reactor
- Electrical Resistance Variation of MWCNT/PMMA Composite for Gaseous Toluene Detection
- Generation of uniform tetrapod-shaped zincoxide nanoparticles by gas-phase reaction with using flow restrictor
- Encapsulation of Citral Isomers in Extracted Lemongrass Oil with Cyclodextrins : Molecular Modeling and Physicochemical Characterizations
- High-Temperature Removal of Acetaldehyde in a Corona Discharge Reactor
- SYNERGETIC EFFECT IN DECOMPOSITION OF ORGANIC COMPOUNDS BY CORONA DISCHARGE AND UV
- Production of Carbon Nanoparticles Using Pulsed Arc Discharge Triggered by Dielectric Breakdown in Water
- WATER PURIFICATION BY FLUIDIZED BED PHOTOCATALYTIC REACTOR USING TiO2-COATED CERAMIC PARTICLES
- Encapsulation of Curcumin Loaded Oil Droplets with Chitosan Based Cryogel: Influence of Freezing Condition on Nanocapsule Properties
- In Situ Estimation of Selective Capture of Tungsten Carbide Particles from Mixture with Diatomite Particles by Mesh-Stacked Dielectrophoresis Separator
- WATER PURIFICATION BY CYLINDRICAL WETTED-WALL REACTOR USING GASEOUS CORONA DISCHARGE
- Wetted-Wall Dielectrophoretic Separator for Collection of TiO2 from SiO2-TiO2 Particle Mixture Dispersed in Ethanol
- Wetted-Wall Dielectrophoretic Separator for Collection of TiO_2 from SiO_2- TiO_2 Particle Mixture Dispersed in Ethanol