Effect of CaS Product Layer Sintering on Limestone-H2S Reaction.
スポンサーリンク
概要
- 論文の詳細を見る
Properties of the CaS produced from sulfidation of limestone and its effect on sulfidation rate were investigated by using TG, BET and SEM techniques. CaS produced from limestone had an initial specific surface area of about 6.1 × 10<SUP>3</SUP> m<SUP>2</SUP>·kg<SUP>–1</SUP> with grain size about 0.25 <I>μ</I>m, but fell to 0.6 × 10<SUP>3</SUP> m<SUP>2</SUP>·kg<SUP>–1</SUP> after sulfidation of 40 minutes due to CaS sintering. The CaS sintering led the product layer to shrink and lose porosity, and in turn to affect H<SUB>2</SUB>S gas diffusion in to the reaction surface. Conversion of 5 <I>μ</I>m sizes particle only reached about 45% at sulfidation of 25 minutes. An unsteady state product layer diffusion model was developed for describing a gas-solid reaction with a shrinking product layer. In the product layer, the effective diffusion coefficient, D<SUB>es</SUB>(r) was varied with radius r and also with time t. The D<SUB>es</SUB>(r) was determined by porosity changes of the product layer. Good agreement was noticed between calculation and experiment results. According to this model, conversion of 100% is possible obtained by sulfidating limestone particle smaller than 5 <I>μ</I>m.
- The Society of Chemical Engineers, Japanの論文
著者
-
Lin Shi
Department Of Energy Engineering & Science Faculty Of Engineering Nagoya University
-
Matsuda Hitoki
Department Of Chemical Engineering Nagoya University
-
Hasatani Masanobu
Department Of Chemical Engineering Nagoya University
-
Matsuda Hitoki
Department of Energy Engineering & Science/Chemical Engineering, Nagoya University
-
Hasatani Masanobu
Department of Energy Engineering & Science/Chemical Engineering, Nagoya University
関連論文
- MEASUREMENT OF PARTICLE FLOW BEHAVIOR IN A PILOT-PLANT MULTI-SOLID FLUIDIZED BED COMBUSTOR BY USING SUCTION PROBE TECHNIQUE
- TRANSPORT VELOCITY OF COARSE PARTICLES IN MULTI-SOLID FLUIDIZED BED
- PADIAL GAS MIXING IN THE BOTTOM PART OF A MULTI-SOLID FLUIDIZED BED
- PRESSURE FLUCTUATIONS IN A MULTI-SOLID FLUIDIZED BED
- マウス肝細胞のmPer2発現に対する上皮成長因子・デキサメサゾン・インスリンの影響
- Heavy Metal Sulfuration with Sulfur and Sodium Hydroxide for Fly Ash Immobilization
- Volatilization behavior of lead from molten slag under conditions simulating municipal solid waste melting
- Reductive decomposition of waste gypsum with SiO_2, Al_2O_3, and Fe_2O_3 additives
- Conversion of Heavy Metals Involved in Incineration Fly Ashes to Heavy Metals Sulfide Resources by Sulfidation Treatment with Sodium Sulfide
- Diffusion Kinetic Modeling of Fluoride Removal from Aqueous Solution by Charge-Reversed Zeolite Particles
- Effect of unburned carbon on lead, zinc, and copper recovery from molten fly ash by chloride-induced volatilization
- PREPARATION OF ZrO_2 FINE PARTICLES BY SPRAY PYROLYSIS METHOD IN FLUIDIZED BED
- SPRAY PYROLYSIS IN A CIRCULATING FLUIDIZED BED
- ENHANCEMENT OF HEAT TRANSFER RATE IN A FALLING FILM LAYER BY ULTRASONIC IRRADIATION
- FLUIDIZATION CHARACTERISTICS OF A CIRCULATING FLUIDIZED BED WITH AN INTERNAL NOZZLE
- Characteristics of Flue Gases and Ash in Oxygen-Blown Pulverized Coal Combustion
- Studies on Phase Change Characteristics of Binary Mixtures of Erythritol and MgCl_2・6H_2O
- Effect of Ultrasonic Irradiation Parameters on the Supercooling Relaxation Behavior of PCM
- Influence of Ultrasonic Irradiation on the Solidification Behavior of Erythritol as a PCM
- Relaxation of Supercooling of Erythritol for Latent Heat Storage
- Characteristics of a Heat Output of an Adsorption Heat Pump Aided with Pumping
- Investigation on the Drying Kinetics in a Pulsed Fluidized Bed
- Optimal Design of a Fin-type Silica Gel Tube Module in the Silica Gel/Water Adsorption Heat Pump
- Heat and Mass Transfer Characteristics of an Active Carbon/Ammonia Adsorption Heat Pump with a Packed Bed Type Adsorber
- Performance of Flammability and NO_X Emission in Premixed Oil Burner Using Ultrasonic Atomization
- Performance of 2kW Adsorption Heat Pump for Producing Cold Heat Energy
- Feasibility Study of Producing High Level Cold Heat Energy by a Carbon/Ammonia Adsorption Heat Pump
- Hydrophilication of Activated Carbon by Impregnating Silica into Pores
- Intraparticle Heat and Mass Transfer Characteristics of Water Vapor Adsorption
- Reaction Characteristics of BaO/BaCO_3 System for High Temperature Chemical Heat Pump above 1273 K
- Study of Decarbonation of CaCO_3 for High Temperature Thermal Energy Storage
- Heat and Mass Transfer Characteristics in Adsorption of Water Vapor for Silica Gel Packed Bed Adsorber
- Study of Carbonation of CaO for High Temperature Thermal Energy Storage
- STUDY OF CO_2 ADSORPTIVITY OF ADSORBENTS UNDER HIGH TEMPERATURE AND PRESSURE FOR INORGANIC OXIDE-CO_2 CHEMICAL HEAT PUMP
- KINETIC STUDY ON REACTIONS OF H_2S WITH LIMESTONE AND HALF-CALCINED DOLOMITE
- Hydrogen Production by Methane-Rich Combustion in a Ceramic Burner
- HYDRATION CHARACTERISTICS OF METAL HYDRIDE FIXED IN RESIN FORM
- FLAMMABILITY AND TEMPERATURE DISTRIBUTIONS IN A CIRCULATING FLUIDIZED BED GAS COMBUSTOR
- H_2S REACTIONS WITH LIMESTONE AND CALCINED LIMESTONE
- FORMATION BEHAVIOR OF CaSO_3 DURING HIGH-TEMPERATURE DESULFURIZATION WITH Ca-BASED SORBENTS
- CHARACTERISTICS OF HELIUM ADSORPTION ON MICROPOROUS SOLIDS UNDER CRYOGENIC CONDITIONS
- Influence of H_2 on the decomposition of halides by nonthermal plasma incorporated with in situ alkaline absorption
- Production of Cold Heat Energy by Alcohol/Activated Carbon Adsorption Heat Pump with a Disk-Module-Type Adsorber
- APPLICABILITY OF CARBONATION/DECARBONATION REACTIONS TO HIGH-TEMPERATURE THERMAL ENERGY STORAGE AND TEMPERATURE UPGRADING
- STUDY OF CARBONATION REACTIONS OF Ca-Mg OXIDES FOR HIGH TEMPERATURE ENERGY STORAGE AND HEAT TRANSFORMATION
- UTILIZATION OF HIGHLY IMPROVED FLY ASH FOR SO_2 CAPTURE
- COMPARATIVE REACTIVITY OF Ca(OH)_2-DERIVED OXIDES FOR SO_2 CAPTURE
- Effect of Coexisting FeO on Volatilization of PbO from CaO-SiO2-Al2O3-FeO Molten Slag in N2 Atmosphere
- MECHANISM OF METHANE-AIR COMBUSTION ON THE SURFACE OF A POROUS CERAMIC PLATE
- Effective thermal conductivity of insulating-refractory material.
- Drying of moist porous particles in a batch fluidized bed.
- Adsorption equilibria of moisture in organic solvents on molecular sieve and ion-exchange resin.
- The Evaluation of Direct Cooling and Heating Desiccant Device Coated with FAM
- Effect of Coexisting FeO on Volatilization of PbO from CaO-SiO_2Al_2O_3-FeO Molten Slag in N_2 Atmosphere
- Effect of pore size distributions of original carbonized materials on development of pores during activation.
- A consideration of the effect of phonon on thermal conductivity during the course of reaction state.
- Effect of CaS Product Layer Sintering on Limestone-H2S Reaction.
- Incineration behavior of wasted liquid droplets and NOx emission with combustion of methane in riser.
- Effect of isotropic scattering on unsteady heat transfer in a fine-particle semitransparent liquid suspension layer heated by collimated radiation.
- Heat transfer and heat storage characteristics of optically semitransparent-material packed-bed solar air heater.