ENHANCEMENT OF HEAT TRANSFER RATE IN A FALLING FILM LAYER BY ULTRASONIC IRRADIATION
スポンサーリンク
概要
- 論文の詳細を見る
This study is concerned with enhancing the heat transfer rate in a falling film layer of ethylene glycol on an inclined rectangular tray by applying ultrasonic waves irradiated from the bottom of the tray. The heat transfer coefficient in a falling film layer of ethylene glycol was determined by the measured temperature distributions under various conditions of liquid flow rate, power supplied to an ultrasonic vibrator and frequency of the ultrasonic wave. The evaporation rate of water from a failing film of ethylene glycol/water mixture was also measured.As a result, the enhancing effect of ultrasonic irradiation on the heat transfer coefficient was obtained with increasing liquid flow rate. It was found that ultrasonic irradiation of 23.6 kHz was more effective to enhance the heat transfer rate in a falling film layer than 46.9 kHz ultrasonic waves. The heat transfer coefficient in a falling film layer was increased by ultrasonic irradiation in the order about 30%, which was obtained at a film Reynolds number of 50.0 by using 23.6 kHz ultrasonic waves. It was recognized that ultrasonic waves increased the evaporation rate of water in a falling film of ethylene glycol/water mixture.
- 社団法人 化学工学会の論文
著者
-
Hasatani M
Department Of Energy Engineering & Science Nagoya University
-
Hasatani Masanobu
Department Of Energy Engineering & Science Nagoya University
-
MATSUDA Hitoki
Department of Energy Engineering and Science, Nagoya University
-
Sato M
Department Of Applied Chemistry Utsunomiya University
-
DEGUCHI Seiichi
Department of Energy Engineering & Science, Nagoya University
-
IMAMURA Yoshinori
Chiyoda Corporation
-
SATO Masanori
Honda Electronics Co., Ltd.
-
Matsuda Hitoki
Department Of Chemical Engineering Nagoya University
-
Deguchi Seiichi
Department Of Energy Engineering & Science Nagoya University
-
Sato Masanori
Honda Electronics Co. Ltd.
-
Hasatani Masanobu
Department Of Chemical Engineering Nagoya University
-
Hasatani Masanobu
Mechanical Engineering Aichi Institute Of Technology
関連論文
- MEASUREMENT OF PARTICLE FLOW BEHAVIOR IN A PILOT-PLANT MULTI-SOLID FLUIDIZED BED COMBUSTOR BY USING SUCTION PROBE TECHNIQUE
- TRANSPORT VELOCITY OF COARSE PARTICLES IN MULTI-SOLID FLUIDIZED BED
- PADIAL GAS MIXING IN THE BOTTOM PART OF A MULTI-SOLID FLUIDIZED BED
- PRESSURE FLUCTUATIONS IN A MULTI-SOLID FLUIDIZED BED
- Heavy Metal Sulfuration with Sulfur and Sodium Hydroxide for Fly Ash Immobilization
- Volatilization behavior of lead from molten slag under conditions simulating municipal solid waste melting
- Reductive decomposition of waste gypsum with SiO_2, Al_2O_3, and Fe_2O_3 additives
- Conversion of Heavy Metals Involved in Incineration Fly Ashes to Heavy Metals Sulfide Resources by Sulfidation Treatment with Sodium Sulfide
- Diffusion Kinetic Modeling of Fluoride Removal from Aqueous Solution by Charge-Reversed Zeolite Particles
- Effect of unburned carbon on lead, zinc, and copper recovery from molten fly ash by chloride-induced volatilization
- Singular Finite Elements for the Die-Swell Simulation of Viscoelastic Fluids
- Practical Correlation of Excess Molar Volumes of Binary, Ternary and Quaternary Mixtures of Water, Methanol, Ethanol and 1-Propanol by an NRTL-Type Equation
- Application of a Singular/Decoupled Finite Element Method to the Viscoelastic Die-swell Flow Simulation
- PREPARATION OF ZrO_2 FINE PARTICLES BY SPRAY PYROLYSIS METHOD IN FLUIDIZED BED
- SPRAY PYROLYSIS IN A CIRCULATING FLUIDIZED BED
- ENHANCEMENT OF HEAT TRANSFER RATE IN A FALLING FILM LAYER BY ULTRASONIC IRRADIATION
- FLUIDIZATION CHARACTERISTICS OF A CIRCULATING FLUIDIZED BED WITH AN INTERNAL NOZZLE
- Two-Dimensional Pb(Zr_xTi_)O_3 Ceramics Arrays for a High-Speed Three-Dimensional Imaging System Using a Coded Wavefront
- Characteristics of Flue Gases and Ash in Oxygen-Blown Pulverized Coal Combustion
- Studies on Phase Change Characteristics of Binary Mixtures of Erythritol and MgCl_2・6H_2O
- Effect of Ultrasonic Irradiation Parameters on the Supercooling Relaxation Behavior of PCM
- Influence of Ultrasonic Irradiation on the Solidification Behavior of Erythritol as a PCM
- Relaxation of Supercooling of Erythritol for Latent Heat Storage
- Influence of microwave irradiation on water-vapor desorption capacity of zeolites
- Production and characterization of KOH-activated carbon derived from polychlorinated biphenyl residue generated by the sodium dispersion process
- Characteristics of a Heat Output of an Adsorption Heat Pump Aided with Pumping
- Characteristics of Pressure Fluctuations in a Fluidized Bed of Binary Mixtures
- Characteristics of Selective Atomization of Polar/Nonpolar Substances in an Oleosus Solvent with Ultrasonic Irradiation
- Investigation on the Drying Kinetics in a Pulsed Fluidized Bed
- Optimal Design of a Fin-type Silica Gel Tube Module in the Silica Gel/Water Adsorption Heat Pump
- Heat and Mass Transfer Characteristics of an Active Carbon/Ammonia Adsorption Heat Pump with a Packed Bed Type Adsorber
- Performance of Flammability and NO_X Emission in Premixed Oil Burner Using Ultrasonic Atomization
- Performance of 2kW Adsorption Heat Pump for Producing Cold Heat Energy
- Feasibility Study of Producing High Level Cold Heat Energy by a Carbon/Ammonia Adsorption Heat Pump
- Hydrophilication of Activated Carbon by Impregnating Silica into Pores
- Intraparticle Heat and Mass Transfer Characteristics of Water Vapor Adsorption
- Reaction Characteristics of BaO/BaCO_3 System for High Temperature Chemical Heat Pump above 1273 K
- Study of Decarbonation of CaCO_3 for High Temperature Thermal Energy Storage
- Heat and Mass Transfer Characteristics in Adsorption of Water Vapor for Silica Gel Packed Bed Adsorber
- Study of Carbonation of CaO for High Temperature Thermal Energy Storage
- STUDY OF CO_2 ADSORPTIVITY OF ADSORBENTS UNDER HIGH TEMPERATURE AND PRESSURE FOR INORGANIC OXIDE-CO_2 CHEMICAL HEAT PUMP
- KINETIC STUDY ON REACTIONS OF H_2S WITH LIMESTONE AND HALF-CALCINED DOLOMITE
- Acoustic Response of Piezoelectric Lead-Zirconate-Titanate to a 400 MeV/n Xenon Beam
- Response of Piezoelectric Lead-Zirconate-Titanate to Hypervelocity Silver Particles
- Measurement of Thermal Diffusivity of Nonlinear Optical Polymer Thin Films Using Photoacoustic Method
- EFFECT OF EHD CONVECTION ON MOTION OF A BUBBLE UNDER MICROGRAVITY
- Hydrogen Production by Methane-Rich Combustion in a Ceramic Burner
- HYDRATION CHARACTERISTICS OF METAL HYDRIDE FIXED IN RESIN FORM
- FLAMMABILITY AND TEMPERATURE DISTRIBUTIONS IN A CIRCULATING FLUIDIZED BED GAS COMBUSTOR
- H_2S REACTIONS WITH LIMESTONE AND CALCINED LIMESTONE
- FORMATION BEHAVIOR OF CaSO_3 DURING HIGH-TEMPERATURE DESULFURIZATION WITH Ca-BASED SORBENTS
- P2-44 Behavior of Marine Animals Using Underwater Acoustic Camera(Short oral presentation for posters)
- CHARACTERISTICS OF HELIUM ADSORPTION ON MICROPOROUS SOLIDS UNDER CRYOGENIC CONDITIONS
- Influence of H_2 on the decomposition of halides by nonthermal plasma incorporated with in situ alkaline absorption
- Response of Piezoelectric Lead–Zirconate–Titanate to Hypervelocity Silver Particles
- Acoustic Response of Piezoelectric Lead–Zirconate–Titanate to a 400 MeV/n Xenon Beam
- Subharmonic Waves Generation by Parametric Decay of Bubble Oscillations
- Production of Cold Heat Energy by Alcohol/Activated Carbon Adsorption Heat Pump with a Disk-Module-Type Adsorber
- APPLICABILITY OF CARBONATION/DECARBONATION REACTIONS TO HIGH-TEMPERATURE THERMAL ENERGY STORAGE AND TEMPERATURE UPGRADING
- STUDY OF CARBONATION REACTIONS OF Ca-Mg OXIDES FOR HIGH TEMPERATURE ENERGY STORAGE AND HEAT TRANSFORMATION
- UTILIZATION OF HIGHLY IMPROVED FLY ASH FOR SO_2 CAPTURE
- COMPARATIVE REACTIVITY OF Ca(OH)_2-DERIVED OXIDES FOR SO_2 CAPTURE
- Effect of Coexisting FeO on Volatilization of PbO from CaO-SiO2-Al2O3-FeO Molten Slag in N2 Atmosphere
- MECHANISM OF METHANE-AIR COMBUSTION ON THE SURFACE OF A POROUS CERAMIC PLATE
- Observation of Marine Animals Using Underwater Acoustic Camera
- Two-Dimensional Pb(ZrxTi1-x)O3 Ceramics Arrays for a High-Speed Three-Dimensional Imaging System Using a Coded Wavefront
- Effective thermal conductivity of insulating-refractory material.
- Drying of moist porous particles in a batch fluidized bed.
- Adsorption equilibria of moisture in organic solvents on molecular sieve and ion-exchange resin.
- The Evaluation of Direct Cooling and Heating Desiccant Device Coated with FAM
- Effect of Coexisting FeO on Volatilization of PbO from CaO-SiO_2Al_2O_3-FeO Molten Slag in N_2 Atmosphere
- Effect of pore size distributions of original carbonized materials on development of pores during activation.
- A consideration of the effect of phonon on thermal conductivity during the course of reaction state.
- Effect of CaS Product Layer Sintering on Limestone-H2S Reaction.
- Incineration behavior of wasted liquid droplets and NOx emission with combustion of methane in riser.
- Effect of isotropic scattering on unsteady heat transfer in a fine-particle semitransparent liquid suspension layer heated by collimated radiation.
- Heat transfer and heat storage characteristics of optically semitransparent-material packed-bed solar air heater.