OS2008 AZ31Bマグネシウム合金押出し棒におけるリング圧縮変形に及ぼす軸対称塑性異方性の影響(OS20-2 マグネシウムの変形挙動,OS-20 HCP金属の実験力学と計算力学)
スポンサーリンク
概要
- 論文の詳細を見る
To estimate axial-symmetric plastic anisotropy of AZ31B (Mg-3mass%Al-1mass%Zn) magnesium alloy extruded bar, the Mg specimen with a cube shape was compressed in several directions at various temperatures. The compressive stress-strain curves in the r-, θ-, and z-direction were measured by cube compression test. And the maximum strain ratios of ε_θ/ε_z = 11 and ε_r/ε_z = 10-11 were measured at the temperatures of 100-200℃. The validity of the obtained anisotropic coefficients of Hill's quadratic anisotropic criterion was investigated by the FE analysis for the plastic deformation of the Mg alloy. In the FE analysis, the plastic deformation of the Mg specimen with a ring shape was calculated with/without considering plastic anisotropy. It was found that the estimated frictional coefficient with the FE analysis with considering axial-symmetric plastic anisotropy was higher than that with the conventional FE analysis for the isotropic material.
- 2011-07-16
著者
-
松本 良
大阪大学大学院基礎工学研究科
-
北村 憲彦
名古屋工業大学
-
水野 嘉人
名工大
-
松本 良
大阪大学
-
寺野 元規
名古屋工業大学大学院工学研究科
-
寺本 元規
名工大
-
松本 良
大阪大学大学院工学研究科
-
水野 嘉人
名古屋工業大学大学院工学研究科
関連論文
- 鍛造
- 鋼材-アルミニウム材の異種金属の植込み接合 : フランジ付軸部品の植込み接合法の開発 第2報
- フランジ付軸部品の植込み接合法の開発
- テーパ付プラグ通し試験による微量潤滑下におけるアルミニウム合金の摩擦評価
- 2706 AZ31マグネシウム合金の鍛造加工における変形抵抗と破壊機構(S19-2 アルミニウム合金,マグネシウム合金(2),S19 アルミニウム合金およびマグネシウム合金の創製と加工技術)
- 2557 溶湯法を利用した発泡アルミニウムの型成形(S25-1 多孔質材(1),S25 新機能多孔質材料の創製と評価)
- AZ31マグネシウム合金の鍛造特性に及ぼす熱処理の影響
- テーパ付プラグ通し試験によるマグネシウム合金-表面被覆工具間の無潤滑摩擦測定
- 302 ACサーボプレスを用いたマグネシウム合金の鍛造基礎特性(塑性加工)
- マグネシウム合金の精密鍛造技術