E15 A Method to Increase Material Removal Rate in Tangential-feed Centerless Grinding Performed on Surface Grinder(Grinding technology)

スポンサーリンク

概要

• 論文の詳細を見る

• In our previous study, a new centerless grinding method using surface grinder was proposed. However, the material removal rate was very small owing to the low worktable feed rate. This paper describes a practical method for increasing removal rate while workpiece roundness is maintained at a high level. In this method, the worktable feed rate is adapted appropriately so that the wheel depth of cut is kept constant during grinding. The actual grinding experimental results showed that the same level of workpiece roundness can be achieved only with a half of grinding cycle time once the worktable feed rate is adapted appropriately instead of the constant feed rate during grinding.

• 一般社団法人日本機械学会の論文
• 2009-12-01

著者

• Lin Weimin

  Dept. Of Machine Intelligence And Systems Engineering Akita Prefectural University

• WU Yongbo

  Dept. of Machine Intelligence and Systems Engineering, Akita Prefectural University

• Wu Yongbo

  Dept. Of Machine Intelligence And Systems Engineering Akita Prefectural University

• XU Weixing

  Graduate School, Akita Prefectural University

• SATO Takashi

  Dept. of Machine Intelligence and Systems Engineering, Akita Prefectural University

• Xu Weixing

  Graduate School Akita Prefectural University

• Sato Takashi

  Dept. Of Communications And Computer Eng. Graduate School Of Informatics Kyoto University

• Sato Takashi

  Dept. Of Machine Intelligence And Systems Engineering Akita Prefectural University

関連論文

• Design of an Ultrasonic Elliptic-Vibration Shoe and Its Performance in Ultrasonic Elliptic-Vibration-Shoe Centerless Grinding(Advanced Manufacturing Technology)
• E15 A Method to Increase Material Removal Rate in Tangential-feed Centerless Grinding Performed on Surface Grinder(Grinding technology)
• Investigation of Centerless Grinding (1st Report) -Grinding Force Measurement-
• Reliability Evaluation Environment for Exploring Design Space of Coarse-Grained Reconfigurable Architectures
• The Magnetic Properties Dependence on Wheel-contacting Time During Planar Flow Casting In Fe-based Amorphous Alloy Ribbons
• Accurate I/O Buffer Impedance Self-adjustment using Threshold Voltage and Temperature Sensors
• Accurate I/O Buffer Impedance Self-adjustment using Threshold Voltage and Temperature Sensors (VLSI設計技術)
• PULL-OUT AND SHEAR STRENGTH EQUATIONS FOR HEADED STUDS CONSIDERING EDGE DISTANCE

スポンサーリンク