C-20 CUTTING OF TITANIUM ALLOY USING MINIMUM QUANTITY LUBRICATION (MQL)(Session: Cutting)

スポンサーリンク

概要

• 論文の詳細を見る

• We investigated the amount of wear to cemented carbide tools by cutting a difficult-to-cut titanium alloy material (Ti-6Al-4V) using minimum quantity lubrication (MQL), and obtained results comparable to those using the conventional wet cutting processes. We also experimentally investigated tool coatings suitable for the MQL cutting of titanium alloys and found that the newly developed TiBON coating increases tool life, probably because it has a low coefficient of friction at high temperatures, and therefore provides improved lubricating properties that result in reduced adhesive wear.

• 一般社団法人日本機械学会の論文
• 2006-11-08

著者

• Adachi Hisashi

  Shizuoka Institute Of Science And Technology Mechanical Engineering

• Koshimizu Shigeomi

  Shizuoka Institute Of Science And Technology Mechanical Engineering

関連論文

• An Ultrafine Motion Table Using Piezoelectric Actuator for Ultraprecision Grinding
• Study on an Ultraprecision Grinding Wheel Spindle, Both-end Supported
• C-20 CUTTING OF TITANIUM ALLOY USING MINIMUM QUANTITY LUBRICATION (MQL)(Session: Cutting)

スポンサーリンク