Theoretical Prediction and Control of Welding Distortion in Large Structures Considering Positioning and the Gap between Parts(Mechanics, Strength & Structure Design, INTERNATIONAL SYMPOSIUM OF JWRI 30TH ANNIVERSARY)
スポンサーリンク
概要
- 論文の詳細を見る
Ships and automobiles are fabricated from thin curved plates. To assemble these parts, welding is commonly used. However, it is impossible to avoid distortion induced by welding. The distortion causes problems not only in the assembling process but also in the final products. The shrinkage of the weld zone is just one of the reasons for the distortion during assembly. Other factors, such as positioning, fixtures and welding sequence must be controlled to achieve the required precision. In this research, a finite element method (FEM) for predicting the welding distortion of three-dimensional curved structures for considering positioning and the gap between parts is proposed. In this method, an interface element is introduced to model the joining process. The usefulness of the proposed method is demonstrated through the prediction of the welding distortion of curved plate structures and the influence of the gap correction is investigated.
- 大阪大学の論文
著者
関連論文
- Numerical Simulation of Residual Stress and Deformation Considering Phase Transformation Effects(Mechanics, Strength & Structural Design)
- 354 桁およびパイプ構造を対象とした溶接変形の計測と予測(溶接変形(IV))
- FEM Simulation of Welding Distortion in Thin Curved Structures during Assembly Considering Gap and Misalignment(Mechanics, Strength & Structure Design)
- Theoretical Prediction of Welding Distortion Considering Positioning and the Gap between Parts(Mechanics, Strength & Structure Design)
- 2-4 薄板構造物の溶接組立における変形予測 : (第一報) ギャップおよび目違いを考慮した変形予測
- 6-4 薄板構造物の溶接組立における変形予測(第三報) : 曲面構造物の溶接組立に及ぼすギャップの影響
- 424 曲面構造物の組立における溶接変形に及ぼすギャップの影響
- 413 FEM Simulation of Welding Residual Stress in Modified 9Cr-1Mo Steel Pipe Considering Post-solidification Transformation Effects
- 3-3 Prediction of Welding Distortion During the Assembly Process of Thin Plate Structures (2nd Report) : Effect of Assembly Process on Buckling Deformation
- WS-15 溶接変形予測モデルの開発
- 界面要素を用いたFEMによる溶接高温割れに関する理論的研究(第五報) : 板継溶接時における横収縮および端部割れに及ぼすルートギャップ,仮付け,タブ板の影響
- 2-28 界面要素を用いたFEMによる溶接高温割れに関する理論的研究(第五報) : 板継溶接時におけるルートギャップの変形予測と仮付け間隔の最適化
- Prediction of Deformation for Large Welded Structures Based on Inherent Strain(Mechanics, Strength & Structural Design)
- FEM Simulation of Welding Residual Stress in Multi-pass Butt-welded Modified 9Cr-1Mo Steel Pipe Considering Phase Transformation Effects(Mechanics, Strength & Structure Design)
- Theoretical Prediction and Control of Welding Distortion in Large Structures Considering Positioning and the Gap between Parts(Mechanics, Strength & Structure Design, INTERNATIONAL SYMPOSIUM OF JWRI 30TH ANNIVERSARY)