ギヤシェーパによるコンケーブコニカルギヤの歯切り法 : 第2報,歯面の主曲率半径,許容法線荷重,および一対の歯車の設計(機械要素,潤滑,工作,生産管理など)

概要

論文の詳細を見る
Theoretically, the contact between tooth surfaces of a pair of conical involute gears is the point contact. Hence the tooth surface durability is generally small. "Concave conical gear" was invented in order to overcome this weak point. The 1st report proves that this gear can be cut by tilt-type gear shaper. In this paper, first the principal normal radii at the pitch point are obtained. Secondly, an allowable normal load of a pair of concave conical gears that cut by this method is obtained, which could be larger than that of a pair of conical involute gears. Finally, the designing method of a pair of concave conical gears cut by this method is presented.
一般社団法人日本機械学会の論文
2004-05-25