The effect of step change in surface roughness on a channel flow
スポンサーリンク
概要
- 論文の詳細を見る
The present paper was concerned with a part of the series of study on the flow in a rough wall channel by authors. For the response of a channel flow to the step change in wall condition, the flow through a two-dimensional channel with short length of rough surface has been investigated numerically. The roughness elements were of the repeated square ribs with the pitch ratio W/h=2 (W and h denote the roughness spacing and height, respectively). The length of rough surface was equivalent to the channel width (corresponding to an ”impulse” of surface roughness for the turbulent boundary layer). The surfaces of upstream and downstream from roughness were smooth and were of sufficient length to allow a fully developed in the smooth wall channel (plane Poiseuille flow) to be established. The Navier-Strokes equations (stream function-vorticity formulation) were solved by the finite difference method using the pseudo-unsteady technique. The calculation was performed for the flow in the different three cases of rough wall channel, and for the range of the Reynolds number Re<1000. From the calculation results, the flow pattern over the rough wall, the behavior of vortex in the roughness groove, the velocity distribution, the pressure distribution along the channel and the distribution of wall shear stress were presented. On the first stage, the particular attention was paid to the comparision of flow structure in the rough wall channel for the different three cases. The results showed that the flow structure varied with the different three cases of rough wall chnnel. The distance of readjustment to the plane Poiseuille flow (relaxation distance) depended on both the geometry of rough wall and the Reynolds number. It was noticeable results that the effects of roughness on the flow extended to the upstream region from surface (its distance being roughly 10 times roughness height for the case the upstanding roughness at Re=100).
- 山口大学の論文
著者
-
Osaka Hideo
Department Of Mechanical Engineering Yamaguchi University
-
Osaka Hideo
Department Of Mechanical Engineering
-
Osaka Hideo
Department Of Mechanical Engineering Yamaguchi University.
-
NAKANISHI Suketsugu
Department of Physics, Hiroshima Institute of Technology.
-
Nakanishi Suketsugu
Department Of Physics Hiroshima Institute Of Technology
-
Nakanishi Suketsugu
Department Of Physics Hiroshima Institute Of Technology.
関連論文
- The effect of step change in surface roughness on a channel flow
- Self-preservation of a turbulent boundary layer over d-type roughness
- Structure of the pulsatile blood flow in the vascular with a rough wall
- Multiple correlation of a two-dimensional turbulent wake
- Turbulence measurements in a two-dimensional turbulent wake
- The Coherent Structure of a Plane Turbulent Wall Jet : Analysis with the Four-Quadrant Method : Series B : Fluid Engineering, Heat Transfer, Combustion, Power, Thermophysical Properties
- The Coherent Structure of a Plene Turbulent Wall Jet (Analysis with the VITA Technique and Time Domain Method) : Series B : Fluids Engineering, Heat Transfer, Combustion, Power, Thermophysical Properties
- Three-Dimensional Jets Issuing from Cruciform Nozzles having four aspect rartio : 1st Report, Mean Flow Properties
- Management of a Stronger Wall Jet by an Embedded Streamwise Vortex : Reynolds Stresses Distributions and Evaluation of the Vorticity Transport Equation
- A Numerical Study on the Blood Flow in an Artery with a Rough Surface (1st Report, Steady Flow) : Series B : Fluids Engineering, Heat Transfer, Combustion, Power, Thermophysical Properties
- Effect of wall roughness on velocity distribution in channel flow : relation between the vortex pattern in roughness groove and flow pattern over the rough wall
- A Numerical Study on the Blood Flow in an Artery with a Rough surface (2nd Report, Pulsatile Flow) : Series B : Fluids Engineering, Heat Transfer, Combustion, Power, Thermophysical Properties
- Streamwise Vortical Structure Associated with the Bursting Phenomenon in the Bursting Phenomenon in the Turbulent Boundary Layer over a d-Type Rough Surface at a Low Reynolds Number : Series B : Fluid Engineering Heat Transfer Combustion, Power Thermophys
- The Coherent Structure of a Turbulent Boundary Layer Over a d-Type Rough Surface at a Low Reynolds Number : Analysis With the Four Quadrant Method
- On The Detection of the Bursting Events with the VITA Technique : Series B : Fluid Engineering, Heat Transfer, Combustion, Power, Thermophysical Properties
- The Coherent Structure of a Turbulent Boundary Layer over a d-Type Rough Surface : Analysis with the VITA Technique and the Four Quadrant Method : Series B : Fluid Engineering, Heat Transfer, Combustion, Power, Thermophysical Properties
- The coherent structure of a turbulent boundary layer over a d-type rough surface at a low Reynolds number : Analysis with the VITA technique and statistical characteristics : Series B : Fluid Engineering, Heat Transfer, Combustion, Power, Thermophysical P