Gear-Cutting Tool for Screw-Compressor Rotors : Built-Up Hob
スポンサーリンク
概要
- 論文の詳細を見る
A built-up hob for a screw-compressor rotor is proposed. The hob is composed of cutter blades and a hob head. The blade is cut out from a tempered planar plate of high speed tool steel by wire-cut electrodischarge machining (EDM). During the wire cutting process, the wire electrode has a fixed angle to ensure both the side and the end relief angle of the cutting edge, so that the rake face regrinding sharpens the cutting edge without changing the profile of the rake face. In other words, theoretically, the hob has no accuracy deterioration due to rake face regrinding. The formulae of rack tooth profile are derived from the female rotor tooth profile expressed by numerical formulae. Next, the fundamental helicoid of the hob and the profile of the cutting edge of the blade are calculated. The hob was fabricated and the rotor hobbing was carried out.
- 一般社団法人日本機械学会の論文
- 2001-09-15
著者
-
Kaneko Katsumi
Graduate School Of Science And Technology Niigata University
-
KAWASAKI Kazumasa
Department of Mechanical and Production Engineering, Niigata University
-
TAMURA Hisashi
Department of Mechanical and Production Engineering, Niigata University
-
Tamura Hisashi
Department Of Mechanical And Production Engineering Faculty Of Engineering Niigata University
-
Kawasaki Kazumasa
Department Of Mechanical And Production Engineering Faculty Of Engineering Niigata University
-
Tamura Hisashi
Department Of Anesthesia And Intensive Care Medicine Yamaguchi Grand Medical Center
関連論文
- Adsorptive Properties of Novel Nanoporous Materials
- Gear-Cutting Tool for Screw-Compressor Rotors : Built-Up Hob
- Measurement of Pinion Type Cutter Using Coordinate Measuring Machine
- Infusion rate of propofol and jugular venous oxygen saturation
- Common Bile Duct Stone Caused by a Fish Bone : Report of a Case
- Method for Cutting Hypoid Gears : Duplex Spread-Blade Method
- GM-14 ESTIMATION OF REAL MACHINE SETTING ON HELIXFORM HYPOID GEAR CUTTING(GEAR MANUFACTURING)