Measurement of Pinion Type Cutter Using Coordinate Measuring Machine
スポンサーリンク
概要
- 論文の詳細を見る
A method for measuring a pinion type cutter using a coordinate measuring machine is proposed. In this method, the cutting edge profile of the cutter is indirectly measured as the intersecting curve between the flank of tool and the cutting face. Left and right side flanks of the cutter are considered to be the tooth surfaces of two different involute helical gears. The coordinates of many points on the tooth surface and the face are measured using a coordinate measuring machine. The tooth surface and the face are estimated from the measured data by the method of least squares. The cutting edge profile is calculated from the estimated tooth surface and the face. The cutting edge is moved helically and it forms the tooth surface of the actual imaginary gear. A pressure angle of this gear can be calculated. Pressure angle error of the pinion type cutter is that of the imaginary gear.
- 一般社団法人日本機械学会の論文
- 2001-03-15
著者
-
Mitome Kenichi
Department Of Mechanical Systems Engineering Yamagata University
-
Mitome Kenichi
Department Of Mechanical Engineering Faculty Of Engineering Yamagata University
-
KAWASAKI Kazumasa
Department of Mechanical and Production Engineering, Niigata University
-
Tamura Hisashi
Department Of Mechanical And Production Engineering Faculty Of Engineering Niigata University
-
LIU Zongxian
Graduate School of Science and Technology, Niigata University
-
Kawasaki Kazumasa
Department Of Mechanical And Production Engineering Faculty Of Engineering Niigata University
-
Tamura Hisashi
Department Of Anesthesia And Intensive Care Medicine Yamaguchi Grand Medical Center
-
Liu Zongxian
Graduate School Of Science And Technology Niigata University
関連論文
- Gear-Cutting Tool for Screw-Compressor Rotors : Built-Up Hob
- Measurement of Pinion Type Cutter Using Coordinate Measuring Machine
- Conical Involute Gear : Part 3. Tooth Action of a Pair of Gears
- Infusion rate of propofol and jugular venous oxygen saturation
- Common Bile Duct Stone Caused by a Fish Bone : Report of a Case
- Method for Cutting Hypoid Gears : Duplex Spread-Blade Method
- GM-14 ESTIMATION OF REAL MACHINE SETTING ON HELIXFORM HYPOID GEAR CUTTING(GEAR MANUFACTURING)