Robust Control of Active Suspensions for a Full Vehicle Model Using Sliding Mode Control

スポンサーリンク

概要

• 論文の詳細を見る

• In this study, a non-linear seven degrees of freedom vehicle model is used in order to design and check the performance of sliding mode controlled active suspensions. Force actuators are mounted as parallel to the four suspensions and a non-chattering control is realized. Sliding mode control is preferred because of its robust character since any change in vehicle parameters should not affect the performance of the active suspensions. Improvement in ride comfort is aimed by decreasing the amplitudes of motions and acceleration of vehicle body. Body bounce, pitch and yaw motions of the vehicle are simulated both in time domain in case of travelling on a limited ramp type of road profile. The robustness of the controller has been proved by using different vehicle parameters such as vehicle mass and damper ratios. Also, phase plane plots of them are plotted. Simulation results are compared with the ones of passive suspensions.

• 一般社団法人日本機械学会の論文
• 2000-06-15

著者

• Yagiz Nurkan

  Department Of Mechanical Engineering Faculty Of Engineering University Of Istanbul

• Yuksek Ismail

  Department Of Mechanical Engineering Faculty Of Engineering Yildiz Technical University

• Sivrioglu Selim

  Mechanical Engineering Lab. Aist Miti

• Sivrioglu Selim

  Mechanical Engineering Lab. , AIST, MITI

関連論文

• SLIDING MODE CONTROL OF A FULL VEHICLE WITH NON-LINEARITY
• Robust Control of Active Suspensions for a Full Vehicle Model Using Sliding Mode Control

スポンサーリンク