Using Acoustic Emission for Monitoring of Grinding Process of Fine Ceramics : Sensitivity of AE to Grain Depth of Cut

スポンサーリンク

概要

• 論文の詳細を見る

• Acoustic emission (AE) was used for in-process detection of ceramic workpiece cracking and chipping during grinding of ceramics. For this purpose AE signals generated during creep feed grinding of alumina were detected using a piezoelectric sensor attached to the workpiece and analyzed by computer. The results prove the sensitivity of different AE parameters to grinding conditions and grinding mode. Particularly, AE parameters show a good correlation with the abrasive grain depth of cut.

• 一般社団法人日本機械学会の論文
• 1995-03-15

著者

• SAITO Yoshio

  Faculty of Science and Engineering, Chuo University

• Akbari Javad

  Faculty Of Engineering Chiba University

• Enomoto Shinzo

  Machinery And Metallurgy Research Institute Of Chiba Pref.

• Hanaoka Tadaaki

  Faculty of Engineering, Chiba University

• Hanaoka Tadaaki

  Faculty Of Engineering Chiba University

• Saito Y

  Hitachi Ltd. Ibaraki Jpn

• Saito Yoshio

  Faculty Of Engineering Chiba University

関連論文

• A New Family of Copper Oxide Compounds with a Tl-O Monolayer: (Tl_Pb_z)(Sr_La_x)_2(Ln_Ce_y)_2Cu_2O_9
• Using Acoustic Emission for Monitoring of Grinding Process of Fine Ceramics : Sensitivity of AE to Grain Depth of Cut
• Acoustic Emission and Deformation Mode in Ceramics During Indentation
• Improvements on Belt Machined Surface Flatness by Using Fuzzy Inference Based on a Simulational Method
• Chaos in Two-Dimensional φ^3 Theory with Oscillator Modes
• Chaos in Two-Dimensional φ^3 Theory with Oscillator Modes
• Growth of SiOx Nanofibers Using FeSi Substrates with Ga Droplets

スポンサーリンク