Fabrication of Composite Material Using Alumina Agglomerated Sludge and Aluminum Powder by Spark Plasma Sintering(<Special Issue>Recent Advances in Materials and Processing [II])
スポンサーリンク
概要
- 論文の詳細を見る
The composite material was fabricated using alumina sludge, industry waste, and aluminum powder by spark plasma sintering (SPS). Sludge of industry waste was treated to change the α alumina crystal structure at temperature 1573K for 2 hours. The bending strength of the composite materials was investigated by changing the volume fraction of sludge 0-6% and forming conditions. As a result, it was found that the sludge content mainly affected on the bending strength. The bending strength showed the highest value at 2% sludge content. From the observation of crack propagation using optical microscope, it became clear that the sludge existed as agglomerated powder in the composite material, and this sludge prevented the crack to propagate.
- 一般社団法人日本機械学会の論文
- 2006-01-15
著者
-
Shibata Shinichi
Department Of Mechanical System Engineering University Of The Ryukyus
-
Shibata Shinichi
Department Of Electrical Communication Shibaura Institute Of Technology
-
Fukumoto Isao
Department of Mechanical Systems Engineering, University of the Ryukyus
-
Mekaru Shunei
Department of Mechanical Systems Engineering, University of the Ryukyus
-
NAKAYAMA Kiyomitsu
Department of Mechanical System Engineering, University of the Ryukyus
-
Fukumoto Isao
Department Of Mechanical System Engineering University Of The Ryukyus
-
Mekaru Shunei
Department Of Mechanical System Engineering University Of The Ryukyus
-
Nakayama Kiyomitsu
Department Of Mechanical System Engineering University Of The Ryukyus
関連論文
- Interval sentinel lymph nodes in patients with cutaneous melanoma : A single-institution study in Japan
- Electronic Linear Acoustic Beam Scanning Using an Interdigital Transducer : Acoustical Measurements and Instrumentation
- Dermoscopic evaluation of vascular structure of various skin tumors in Japanese patients
- 226 Development of Fiber Reinforced Plastic Using Bagasse Fiber by Injection Molding
- Fabrication of Composite Material Using Alumina Agglomerated Sludge and Aluminum Powder by Spark Plasma Sintering(Recent Advances in Materials and Processing [II])
- Evaluation of Mechanical Properties of Injection Molding Composites Reinforced by Bagasse Fiber
- Fabrication of Composite Material Using Gettou Fiber by Injection Molding