226 Development of Fiber Reinforced Plastic Using Bagasse Fiber by Injection Molding

スポンサーリンク

概要

• 論文の詳細を見る

• Bagasse is the waste fiber obtained after squeezing sugar cane. Our purpose is to find a more valuable usage of the bagasse as a composite material. The composite material is compounded unsaturated polyester, crushed bagasse fiber and glass fiber. FRP (Fiber Reinforced Plastic) material in our research was produced by injection molding and injection compression molding using BMC (Bulk Molding Compound) material. The product was investigated about the optimum condition in term of the mechanical strength and property. Consequently, it was found that the glass fiber was penetrated into a bagasse fiber in the injection to the cavity of the mold. The effect of fixing the glass fiber in a batgasse signified equivalently to prolong the glass fiber length. Furthermore, according to the kneading action and capillarity work in BMC, the liquefied unsaturated polyester resin was sufficiently permeated through the bagasse fiber of vegetable fiber. This phenomenon contributed to the improvement of mechanical strength because of the friction increase between resin and bagasse fiber.

• 一般社団法人日本機械学会の論文

著者

• Cao Yong

  University Of Electronic Science And Technology Of China

• Cao Yong

  University Of The Ryukyus

• Fukumoto Isao

  Department of Mechanical Systems Engineering, University of the Ryukyus

• Mekaru Shunei

  Department of Mechanical Systems Engineering, University of the Ryukyus

• Fukumoto Isao

  Department Of Mechanical System Engineering University Of The Ryukyus

• Fukumoto Isao

  Department Of Mechanical Systems Engineering University Of The Ryukyus

• Mekaru Shunei

  Department Of Mechanical System Engineering University Of The Ryukyus

• Mekaru Shunei

  Department Of Mechanical Systems Engineering University Of The Ryukyus

関連論文

• The Software Reliability Model Based on Fractals
• 226 Development of Fiber Reinforced Plastic Using Bagasse Fiber by Injection Molding
• The Software Reliability Model Using Hybrid Model of Fractals and ARIMA
• Fabrication of Composite Material Using Alumina Agglomerated Sludge and Aluminum Powder by Spark Plasma Sintering(Recent Advances in Materials and Processing [II])
• Evaluation of Mechanical Properties of Injection Molding Composites Reinforced by Bagasse Fiber
• Fabrication of Composite Material Using Gettou Fiber by Injection Molding

スポンサーリンク