円筒殻の衝撃外力による局部凹損実験の結果について(第2報)
スポンサーリンク
概要
- 論文の詳細を見る
Following the preceding paper, the author now discuss the effects due to the depth of water to the damages of cylindrical shells, because it seems to him not being well discussed yet on the quantitative measurement of water pressures due to effects of expansion of successive gas globes and damage amounts occurred by explosion in the deep sea.The cylindrical shells used were made of high strength steel and stiffened by inner frames with different span lengths.After hanging the cylindrical shells by wire ropes at the depth of about 30,150 or 300 meters under the water on the about 2,000 meters depth sea, the explosion tests were pursued by blasting TNT spherical explosives from the bottom, yielding to the small damages on shells.This paper is mainly concerned with small local damages occurred between frames, and hence the large ones in case of buckling of frames were disregarded.Comparing both results of experiments and calculations on water pressures and displacements, the semi-empirical formulas of time lag among peak pressures due to gas globes and the amounts of maximum concavities of damages on the cylindrical shells were determined.The formula of maximum concavities was further compared with the experimental formula which was developed quite recently in USA in case of variable depth of water, showing good coincidences between both results up to the so-called safe depth of water.The formula of maximum concavities which is available to the mild steel material was also determined and compared with the experimental results of the cylindrical models carried out by changing the depth of water, showing reasonable coincidences between both calculated and experimental results.
- 社団法人日本船舶海洋工学会の論文
著者
関連論文
- 最大トリム角を制限した高速艇船型
- 高速艇の平水中水槽試験結果に関する主成分分析と因子分析
- 高速域において抵抗が最小となる高速艇船型
- 高速艇に関する平水中水槽試験結果の統計解析
- 波型隔壁板の塑性力学(第1報) : 横衝撃力による波型梁の大きな変形について
- 荒天中における船体の運動, 縦曲げモーメントおよび船首船底水圧の実船計測例
- 有限要素法による平面応力ならびに平面曲げ解析プログラムとその船体構造部材への応用について
- スラミング現象に関する研究の展望
- 水面衝撃による高張力鋼製矩形平板の弾性応答について
- 円筒殻の衝撃外力による局部凹損実験の結果について(第2報)
- 高速艇の横強度について
- 円筒殻の衝撃外力による局部凹損実験の結果について
- 波形隔壁の弾性座屈について
- 波型隔壁板の塑性力学(第4報) : 非中央衝撃の場合
- 波型隔壁板の塑性力学
- 波型隔壁板の塑性力学(第3報) : 横衝撃力を受ける四周固定板の大変形
- 波型隔壁板の塑性力学(第2報)
- 波型隔壁板の塑性力学(第2報) : 横衝撃力を受ける四周支持板の大きな変形
- 波型隔壁板の塑性力学
- 波型隔壁板の塑性力学-2-
- 波型防撓材の応力分布に就いて(1)
- 防撓材なき波型隔壁の一考察(昭和25年11月造船協会秋季講演会)
- 「光学式高度センサ」について
- 衝撃水圧を受ける防撓板の周波数応答解析
- 長矩形平板の水面衝撃実験とその解析
- 軽構造FRP艇の船底部外板の動的設計法について
- 局部振動体のついた梁の過渡振動について
- 水表面を利用する船と飛行艇
- 翼系6分力計システム
- 自航試験動力計用動力循環式較正装置
- 円板弁絞り機構による流量調整弁について
- 模型船自航試験用軸系結合装置
- 水面衝撃による長矩形平板の弾塑性応答について