すみ肉溶接で生じる面外変形の高精度予測

概要

論文の詳細を見る
In order to predict the distortion generated by welding with high accuracy, distortion with fillet welding was measured by three-dimensional photographic measurement. Then, the experiment was simulated by three-dimensional thermal elastic-plastic analysis by FEM. The important matters that should be noted on predicting the distortion with high accuracy were shown by comparing with the results of the experiment and those of the analysis. The results of measuring temperature could be accurately simulated by non-steady state thermal conduction analysis based on FEM. In carrying out the elastic-plastic analysis, four conditions (equilibrium equation, constitutive equation, condition of compatibility and yield condition) should be satisfied. In welding, the temperature largely changed from a melting temperature to a room temperature. So, yield stress of materials largely changed, too. In particular, yield stress becomes about zero above 700℃. The analysis should be carried out under the yield condition that equivalent stress generated in temperature increment ΔT did not exceed yield stress of materials at high temperature above 700℃. It should be sufficiently recognized that the obtained results were not reliable if the yield condition was not satisfied. Angular distortion generated in fillet welding could be accurately predicted by regarding the weld metal as a deposited metal not assuming that a deposited metal zone was a simple triangle. Specifying an influence factor on longitudinal bending distortion was difficult because the absolute value was small. However, it was indicated that the reasonable result could be obtained by regarding the weld metal as a deposited metal because the absolute value of longitudinal bending distortion at pass (2) (the second pass) of which restraint was severer became smaller than that at pass (1) (the first pass).
社団法人溶接学会の論文
2005-08-05

すみ肉溶接で生じる面外変形の高精度予測

スポンサーリンク

概要

著者

関連論文

スポンサーリンク