片面狭開先MAG溶接法の研究(第3報) : 裏波制御溶接方法の開発
スポンサーリンク
概要
- 論文の詳細を見る
The authors have been carrying out practical studies on one-side narrow-gap MAG welding with DCEN polarity. In the previous paper^<1)>, observation of "Uranami bead" shapes and determination of suitable range of welding condition for "Uranami Welding" were carried out and it was made clear that "Uranami beads" without defect could be achieved over a wide range of welding conditions with this welding method. However, in case of long weld line and changing groove width, it became clear too that fine adjustment of welding conditions (mainly adjustment of welding speed) would be necessary in order to achieve constant shapes of "Uranami bead" all along the weld line. Consequently, the relationships between arc phenomena in "Uranami welding" and shapes of "Uranami bead" were observed, and it was found that the shape of the "Uranami bead" was dependent on the welding speed and the wave pattern of the welding current. Based on these results, a new "Uranami welding" control method was developed. In this method, a control signal which was obtained by monitoring the welding current with a micro-computer, was used to adjust the welding speed continuously in order to achieve a good "Uranami bead". Application of this control system to one-side narrow-gap MAG welding with DCEN polarity confirmed that uniform "Uranami beads" could be obtained even if the root gap varies from 9 to 12 mm.
- 1986-05-05
著者
関連論文
- 狭開先内における電極ワイヤの溶融特性
- 溶接アーク周辺における探針の電流・電圧特性 : 探針による溶接開先の左右方向ならいの研究(第一報)
- 210 開先内における溶接ワイヤのずれとアーク周辺の電位との関係 : アーク現象を用いた自動ならい溶接の試み(第2報)
- 209 溶接アーク周辺の電位とその開先自動ならいへの適用 : アーク現象を用いた自動ならい溶接の試み(第1報)
- 鋼のCO_2アークスポット溶接(第2報) : アーク熱による母板の動的変形挙動
- 狭開先MAG溶接における溶込み形状の観察
- 鋼の CO_2 アークスポット溶接(第 1 報)
- 狭開先 MAG 溶接における溶滴の平均保有熱量 : 開先広さの影響
- 狭開先内における電極ワイヤの溶融特性(第 2 報) : シールドガス組成の影響
- 237 DCEN片面狭開先MAG溶接法の研究(第2報) : 裏波制御溶接の研究
- 疲れ強さに及ぼす溶接線の蛇行の影響
- 片面狭開先MAG溶接法の研究(第3報) : 裏波制御溶接方法の開発
- 片面狭開先MAG溶接法の研究(第2報) : 裏波ビード形状に及ぼす諸要因の影響
- 片面狭開先MAG溶接法の研究(第1報) : 直流棒マイナス極性における裏波ビード形状の観察
- MAG狭開先溶接の凝固割れ試験法と凝固割れにおよぼすボロンの影響(平成2年度春季全国大会論文発表講演論文)
- 鋼のCO_2アークスポット溶接(第3報) : 継手の特性に及ぼす板間隙の影響