Prevention of Lamellar Tearing in Multipass Welded Corner Joint
スポンサーリンク
概要
- 論文の詳細を見る
Lamellar tearing of opening type occasionally occurs in multipass welded corner joints. Effects of gas cutting for the edge surface of the vertical plate and shapes of groove on the occurrence of the lamellar tearing are investigated experimentally and theoretically. The main results obtained in this study are as follows. (1) In the cases where the edge surface of the vertical plate is prepared by gas cutting or machine, the transverse welding residual stress on the edge surface of the vertical plate reaches approximately the yield point at a position 10 mm away from the toe and the lamellar tearing occurs, when the intensity of bending restraint increases. No difference between these cases is observed in the critical intensity of bending restraint for lamellar tearing. (2) In order to reduce transverse welding residual stresses and to prevent the occurrence of the lamellar tearing, it is effective to use such a groove that the edge of the vertical (web) plate is projected out of the upper surface of the flange plate or that the vertical plate is cut obliquely.
- 社団法人溶接学会の論文
著者
-
Ueda Yukio
Welding Research Institute, Osaka University
-
Fukuda Keiji
Welding Research Institute Of Osaka University
-
NISHIMURA Iwao
Kurimoto Iron Works, Ltd.
-
IIYAMA Hideaki
Kurimoto Iron Works, Ltd.
-
CHIBA Naomichi
Kurimoto Iron Works, Ltd.
-
Ueda Yukio
Welding Research Institute Of Osaka University
関連論文
- 10. Development of Computer Aided Process Planning System for Plate Bending by Line-Heating
- Three Dimensional Cold Bending and Welding Residual Stresses in Penstock of 80kgf/mm^2 Class High Strength Steel Plate(Welding Mechanics, Strength & Design)
- Effect of Intensity of Bending Restraint on Weld Cracking in Multipass Weld
- Application of Finite Element Method for Analysis on Process of Stress Relief Annealing
- Prediction of Welding Residual Stresses in T-and I-Joints Using Inherent Strains : A predicting method of welding residual stress using source of residual stress (Report 3)
- Prevention of Lamellar Tearing in Multipass Welded Corner Joint
- Effects of Intensity of Bending Restraint on Lamellar Tearing and Root Cracking in Corner Joint
- Dynamical Characteristics of Weld Cracking in Multipass Welded Corner Joint
- 12. Ultimate Strength of Stiffened Plates and Minimum Stiffness Ratio of Their Stiffeners
- Modern Method of Ultimate Strength Analysis of Offshore Structures(Physics, Process, Instrument & Measurement)