Estimation of Residual Stress in Dental Porcelain by Laser-Raman Spectroscopy

概要

論文の詳細を見る
Residual stress in the surface of dental porcelain was estimated using laser Raman spectroscopy. Sixteen different magnitudes of residual stress were generated in commercial porcelain disks by tempering, ion exchange, and slow colling. The specimens were analyzed using a laser-Raman spectrometer with an Ar^+laser. The Raman shift of the largest peak near 500 cm^<-1> originating from silica was used as an indicator of the level of residual stress. For comparison, the residual stress in the specimen was estimated by the indentation micro-fracture method. The Raman shift of the porcelain increased with increasing residual stress at 3.7×10^<-2>cm/MPa(R^2=0.89). The increase in the Raman shift corresponded to the increase in compressive stress. In addition, the value of full width at half maximum on the peak corresponded to the residual stress (-1.57×10^<-1>cm^<-1>/MPa:R^2=0.82). These results revealed that the increase of residual stress in porcelain clearly appears on the Raman spectrum as an increase in the Raman shift. It is thus feasible to estimate residual stress in porcelain by laser-Raman spectroscopy.
日本歯科理工学会の論文