Analytical and Experimental Investigation for Tensile and Compressive Creep of the A3003P Aluminium Alloy Used for Plate-Fin Heat Exchanger

スポンサーリンク

概要

• 論文の詳細を見る

• Analytical and experimental analysis for tensile and compressive creep properties of fine and coarse-grained aluminium alloy, A3003P, used for plate-fin heat exchanger are presented for temperatures from 400℃ to 600℃ and stresses between 0.255 MPa and 6.370 MPa. Investigation for parameters' effect on the behaviour of the time-dependent flow of material was carried out. For analytical investigation, the grain-size mechanism was applied to both tension and compression creep tests. Creep-strain rate increases with increasing both temperature and stress, while decreasing with coarse grain size. For loading mode, experimental results showed lower creep strain in compression than in tension for all stresses investigated. Nevertheless, numerical analysis showed identical behaviour for both tension and compression. Good agreement was found between the experimentally determined creep strain and analytical predictions at lower stress levels. However, at higher stresses considerable deviations from the experimental results were recorded for the analytical findings. Though the grain-size mechanism is applicable in case of tension for pure aluminium, modification becomes necessary when compression is applied.

• 一般社団法人日本機械学会の論文
• 1999-07-15

著者

• El-shennawy Mohamed

  Kobe University Graduate School Of Science And Technology

• MORITA Yoshiyasu

  Kobe University, Faculty of Engineering, Department of Mechanical Engineering

• KOUSO Masashi

  Sumitomo Precision Products Company, Ltd., Heat Management and Systems, Engineering Department

• Kouso Masashi

  Sumitomo Precision Products Company Ltd. Heat Management And Systems Engineering Department

• Morita Yoshiyasu

  Kobe University Faculty Of Engineering Department Of Mechanical Engineering

関連論文

• Small-Size Fracture Toughness Specimen with High Plastic Constraint Generated by Mechanical Heterogeneity〔含 討論〕
• Constraint Effect by Strength Mis-Matching and Its Application to KIC-Measurement〔含 討論〕
• Analytical and Experimental Investigation for Tensile and Compressive Creep of the A3003P Aluminium Alloy Used for Plate-Fin Heat Exchanger

スポンサーリンク