Steady-State Response Analysis of Elastically Point-Supported Composite Rectangular Plates
スポンサーリンク
概要
- 論文の詳細を見る
This paper presents an analytical method for determining the steady-state response of a laminated composite fectangular plate resting on some elastic point supports. The bending rigidities are assumed to be complex quantities considering material damping. The Ritz approach is used to yield a governing equation of motion for the plate, and the steady-state response solution to a sinusoidally varying point force is derived. The method is applied to a laminated square plate elastically supported at four points symmetrically located at the corners or on the diagonals. The mechanical impedance of the plate is calculated for three types of FRP (fiber-reinforced plastic) materials, and the effects of the point supports and the lamination properties upon the response characteristics are studied.
- 一般社団法人日本機械学会の論文
- 1990-09-15
著者
-
NARITA Yoshihiro
Department of Mechanical Systems Engineering Hokkaido Institute of Technology
-
MARUYAMA Kouichi
Department of Environmental Studies, Graduate School of Environmental Studies, Tohoku University
-
ICHINOMIYA Osamu
Department of Electronics, Faculty of Engineering, Kyushu University
-
Narita Y
Hokkaido Inst. Technol. Sapporo Jpn
-
Narita Yoshihiro
Department Of Mechanical Engineering Hokkaido Institute Of Technology
-
Ichinomiya O
Hokkaido Inst. Technology
-
Ichinomiya Osamu
Department Of Electronics Faculty Of Engineering Kyushu University
-
Maruyama Kouichi
Department Of Anesthesiology Saitama International Medical Center Saitama Medical University
関連論文
- Vibration Analysis of Shear-deformable Circular and Elliptical Laminated Composite Plates(Special Issue on Advances in Dynamics and Design of Continuous Systems)
- Microstructure and Mechanical Properties of Mg-Al-Ca-Nd Alloys Fabricated by Gravity Casting and Extrusion Process
- The Effects of Yttrium Element on Microstructure and Mechanical Properties of Mg-5 mass%Al-3 mass%Ca Based Alloys Fabricated by Gravity Casting and Extrusion Process
- Formation of Slit-Like Voids at Trench Corners of Damascene Cu Interconnects
- Electrochemical Hydrogen-Storage in Ti-Mn Alloy Electrodes
- A METHOD FOR SOLVING THE THREE DIMENSIONAL VIBRATION OF A UNIDIRECTIONAL COMPOSITE PARALLELEPIPED
- Dynamic response of unsymmetrically laminated rectangular plate with concentrated masses
- Steady-State Response Analysis of Elastically Point-Supported Composite Rectangular Plates
- Strengthening Mechanisms of Creep Resistant Tempered Martensitic Steel
- Can intravenous atropine prevent bradycardia and hypotension during induction of total intravenous anesthesia with propofol and remifentanil?
- Suspected recurrent anaphylaxis in different forms during general anesthesia
- Prediction of Long Term Creep Curve and Rupture Life of 2.25Cr-1Mo Steel
- Improvement of Omega Method for Creep Life Prediction
- Forward(Special Issue on Advances in Dynamics and Design of Continuous Systems)
- EXPERIMENTAL STUDY OF FREE VIBRATION OF CIRCULAR PLATES WITH A STRAIGHT ECCENTRIC NARROW SLIT
- Experimental Study of Free Vibration of Clamped Rectangular Plates with Straight Narrow Slits
- Free Vibration Analysis of Cantilevered Composite Plates of Arbitrary Planform