501 Drilling of AFRP with YAG Laser
スポンサーリンク
概要
- 論文の詳細を見る
Because of their high properties, FRPs (Fiber Reinforced Plastics) have been at the center of attention. They consist of the high-strength and high-modulus fibers and the heat-resistant and corrosive-resistant plastics. In some cases, FRP is required to be machined to apply it to the electronic parts etc, especially very high performance drilling. Therefore in this research, hole drilling of FRP with YAG laser is treated as the objective and the workability is inquired into in detail. Irradiating time and flash lamp voltage are changed in wide range and the hole configuration and HAZ are observed. The appropriate conditions of YAG laser are proposed clearly.
- 一般社団法人日本機械学会の論文
著者
-
Sawaki Yutaka
Department Of Mech. Engineering Faculty Of Engineering Mie University
-
Sawaki Yutaka
Dept. Of Mechanical Engineering Mie Univ.
-
Nakanishi Eitoku
Dept. of Mechanical Engineering, Mie Univ.
-
Isogimi Kiyoshi
Dept. of Mechanical Engineering, Mie Univ.
-
NAKANISHI Eitoku
Department of Mech. Engineering, Faculty of Engineering, Mie University
-
ISOGIMI Kiyoshi
Department of Mech. Engineering, Faculty of Engineering, Mie University
-
YOSHIMOTO Takao
Dept. of Mech. Engg., Fact. of Engg., Mie Univ.
-
Isogimi Kiyoshi
Department Of Mech. Engineering Faculty Of Engineering Mie University
-
Isogimi Kiyoshi
Dept. Of Mechanical Engineering Mie Univ.
-
Yoshimoto Takao
Dept. Of Mech. Engg. Fact. Of Engg. Mie Univ.
-
Nakanishi Eitoku
Department Of Mech. Engineering Faculty Of Engineering Mie University
関連論文
- Mechanical Evaluation of Cardiac Contractility in Left Ventricle with Disease Using Magnetic Resonance Tagging Technique
- Two-Dimensional Deformation Analysis of Human Left Ventricle during Ejection Period Using Magnetic Resonance Tagging Technique
- Numerical Simulator for Estimation of Mechanical Function of Human Left Ventricle : Study of Basic System
- OS12(5)-19(OS12W0176) Fracture Behaviour of Aramid Short fiber FRP Laminates and the Simulation of Energy Absorption Capability
- A Boundary Solution System for the St. Venant Problem
- YAG Laser Drilling of Aramid FRP Laminates(Advances in non-traditional machining)
- 529 Machining Process of Aramid Fiber Reinforcing Plastics
- 501 Drilling of AFRP with YAG Laser
- Effect of Fiber Surface Treatment on the Interface and Bending Strength of Aramid Short Fiber Composite
- Bending Properties of Aramid Short Fiber Composite and Modeling of Strength
- OS1(4)-18(OS01W0077) Fundamental Study of Caustic Experimental Method in Thermal Stress Analysis : Investigation for One or Two Dimensional Stress Field in Circular Disk
- Machinability and Phenomena in Laser Drilling of Aramid FRP(Electronic Devices)
- Application of Caustics Experimental Method to Dynamic Cutting Stress Analysis(Optical Method 1)
- Stress Measurement Using the Caustics Method under Distributed Load Conditions