529 Machining Process of Aramid Fiber Reinforcing Plastics
スポンサーリンク
概要
- 論文の詳細を見る
The machining of composite materials becomes very difficult due to the differences of properties between the reinforcing materials and matrix materials. Especially the machining an A-FRP (Aramid fiber reinforcing plastics) causes the rough machined surfaces. The surface integrities are much affected by orientation of fibers. To clarify the effect of fiber orientation on the surface appearances, we observed the deformation and fractural phenomena of Aramid fiber during machining A-FRP by microscopically. And we can make an interior deformation and fracture of fiber clear that is situated in the matrix. Further, we simulated the phenomena with a very simple model to evaluate the deformation of Aramid fiber during machining. It is based on Dr. Timoshenko's theory of beams on elastic foundation. In our analysis, the beams are regarded as Aramid fibers and the elastic foundation is regarded as matrix material. Further, the modulus of the foundation is varied to prove the orientation of fiber. The calculated results have some coincides with experimental results.
- 一般社団法人日本機械学会の論文
著者
-
Sawaki Yutaka
Department Of Mech. Engineering Faculty Of Engineering Mie University
-
Sawaki Yutaka
Dept. Of Mechanical Engineering Mie Univ.
-
Nakanishi Eitoku
Dept. of Mechanical Engineering, Mie Univ.
-
Isogimi Kiyoshi
Dept. of Mechanical Engineering, Mie Univ.
-
NAKANISHI Eitoku
Department of Mech. Engineering, Faculty of Engineering, Mie University
-
ISOGIMI Kiyoshi
Department of Mech. Engineering, Faculty of Engineering, Mie University
-
Isogimi Kiyoshi
Department Of Mech. Engineering Faculty Of Engineering Mie University
-
Isogimi Kiyoshi
Dept. Of Mechanical Engineering Mie Univ.
-
Nakanishi Eitoku
Department Of Mech. Engineering Faculty Of Engineering Mie University
関連論文
- Mechanical Evaluation of Cardiac Contractility in Left Ventricle with Disease Using Magnetic Resonance Tagging Technique
- Two-Dimensional Deformation Analysis of Human Left Ventricle during Ejection Period Using Magnetic Resonance Tagging Technique
- Numerical Simulator for Estimation of Mechanical Function of Human Left Ventricle : Study of Basic System
- OS12(5)-19(OS12W0176) Fracture Behaviour of Aramid Short fiber FRP Laminates and the Simulation of Energy Absorption Capability
- A Boundary Solution System for the St. Venant Problem
- YAG Laser Drilling of Aramid FRP Laminates(Advances in non-traditional machining)
- 529 Machining Process of Aramid Fiber Reinforcing Plastics
- 501 Drilling of AFRP with YAG Laser
- Effect of Fiber Surface Treatment on the Interface and Bending Strength of Aramid Short Fiber Composite
- Bending Properties of Aramid Short Fiber Composite and Modeling of Strength
- OS1(4)-18(OS01W0077) Fundamental Study of Caustic Experimental Method in Thermal Stress Analysis : Investigation for One or Two Dimensional Stress Field in Circular Disk
- Machinability and Phenomena in Laser Drilling of Aramid FRP(Electronic Devices)
- Application of Caustics Experimental Method to Dynamic Cutting Stress Analysis(Optical Method 1)
- Stress Measurement Using the Caustics Method under Distributed Load Conditions