静的シールの設定圧着応力に及ぼす表面粗さの影響 : 第2報,金属ガスケットとしてのシール特性

概要

論文の詳細を見る
rights: 本文データは社団法人日本機械学会の許諾に基づき、CiNiiから複製したものであるIn this paper, the effect of surface roughness appearing on a turned sealing surface on compressive stress and compressive force of copper gaskets (a fiat gasket, a ring joint gasket and a copper wire gasket) was studied. The results obtained can be summarized as follows : (I) In the case of a flat gasket or a ring joint gasket, in order to ignore both the surface roughness appearing on a turned sealing surface and the cross section of gasket, the compressive stress for sealing had to be nearly equal to 1.3 times the tensile strength of the copper gasket. (2) In the case of a ring joint gasket or a copper wire gasket, the values of maximum heigh roughness, in which the minimum compressive force for sealing applied, were found in the region between 2μm and 20μm or not less than 110μm respectively.
一般社団法人日本機械学会の論文
1987-07-25