The Contact Area of Boiling Bubbles on the Heating Surface

スポンサーリンク

概要

• 論文の詳細を見る

• The bottom of the boiling bubble is optically observed by the experiment using the electroconductive glass as the heating surface in water. It is discovered that in the contact part of the boiling bubble with the heating surface there exists a thin liquid layer and that the layer has sometimes a small drying part. The ratio of the area of the contact part of the boiling bubbles to the total heating surface is not 100% but about 50% even near the burn out heat flux.

• 一般社団法人日本機械学会の論文

著者

• Torikai Kinichi

  Japan Atomic Energy Research Institute

• YAMAZAKI Toshi

  Japan Atomic Energy Research Institute

関連論文

• Variation by Time in Boiling Heat Transfer Caused by Generation of Bubbles
• Dry State in a Contact Area of a Boiling Bubble on a Heating Surface
• Piping cracks in JPDR. IV. Analysis of cause of cracks found near weld joints connecting reactor vessel nozzle safe-end to pipe.:Analysis of Cause of Cracks Found near Weld Joints Connecting Reactor Vessel Nozzle Safe-End to Pipe
• Piping cracks in JPDR. I. Relation between crack and stress.:Relation between Crack and Stress
• Piping cracks in JPDR. II. In service inspection of weld joints in reactor coolant pressure boundary.:In Service Inspection of Weld Joints in Reactor Coolant Pressure Boundary
• The Contact Area of Boiling Bubbles on the Heating Surface

スポンサーリンク