Shell-Side Pressure Drop in the Multi-Baffled Shell-and-Tube Heat Exchangers
スポンサーリンク
概要
- 論文の詳細を見る
The baffle plate is the most important factor in the shell-side pressure drop of the multibaffled shell-and-tube heat exchangers. An experimental equipment which consisted of a shell with baffles but had no tube was constructed, and the pressure drop in it was measured and analyzed. The result was compaped with the pressure drop in an experimental heat exchanger which contained both baffles and tubes. Thus a method of estimating the pressure drop in heat exchangers was derived. This method is a simplification of Bell's method and is believed to be more accurate.
- 一般社団法人日本機械学会の論文
著者
-
Nakayama Yoshiaki
Hiroshima Shipyard Mitsubishi Heavy Industries Co.
-
ISHIGAI Seikan
Faculty of Engineering, Osaka University
-
NISHIKAWA Eiichi
Faculty of Engineering, Osaka University
-
TANAKA Shigeo
Hiroshima Shipyard, Mitsubishi Heavy industries Co.
-
SAIDA Ikuo
Hiroshima Shipyard, Mitsubishi Heavy industries Co.
-
FUKUDA Yasusuke
Tsurumi Shipyard, Nippon Kokan K. K.
-
Saida Ikuo
Hiroshima Shipyard Mitsubishi Heavy Industries Co.
-
Ishigai Seikan
Faculty Of Engineering Osaka University
-
Nishikawa Eiichi
Faculty Of Engineering Osaka University
-
Fukuda Yasusuke
Tsurumi Shipyard Nippon Kokan K. K.
-
Tanaka Shigeo
Hiroshima Shipyard Mitsubishi Heavy Industries Co.
関連論文
- Shell-Side Pressure Drop in the Multi-Baffled Shell-and-Tube Heat Exchangers
- Boiling Crisis in the Horizontal Channel : (4th Report, Analysis on Burnout Heat Flux in Annular Mist Flow)
- Measurement of the Component Flows in a Vertical Two-Phase Flow by Making Use of the Pressure Fluctuation : Part 2,The Flow Model for the Slug-Flow and Its Application
- Experimental Study of Structure of Gas Flow in Tube Banks with Tube Axes Normal to Flow Part II ; On the Structure of Gas Flow in Single-Column , Single-Row, and Double-Rows Tube Banks
- Measurement of the Component Flows in a Vertical Two-Phase Flow by Making Use of the Pressure Fluctuation : Part 1,Proposal of a Characteristic Number
- Boiling Crisis in the Horizontal Channel : 3rd Report, Burnout in Uniformly Heated Horizontal Tubes
- Boiling Crisis in the Horizontal Channel : 1st Report, Critical Heat Flux for Square Channel with Separately Heated Top or Bottom
- A Treament for Thermal Efficiency Improvement in the Brayton Cycle
- Experimental Study on Structure of Gas Flow in Tube Banks with Tube Axes Normal to Flow : Part 1, Karman Vortex Flow from Two Tubes at Various Spacings
- Experimental Study of Transition Boiling on a Vertical Wall in Open Vessel
- Flow Instabilities in Boiling Channels : Part 2 Geysering
- Flow Instabilities in Boiling Channels : Part 1 Pressure Drop Oscillation
- On the Flashing Flow of Saturated Water Through Horizontal Pipes
- Heat Transfer of the Impinging Round Water Jet in the Interference Zone of Film Flow along the Wall