Boiling Crisis in the Horizontal Channel : 1st Report, Critical Heat Flux for Square Channel with Separately Heated Top or Bottom
スポンサーリンク
概要
- 論文の詳細を見る
Visual study was made of the flow and boiling pattern near critical heat flux in the horizontal square ducts, and the critical heat flux was measured at the top or the bottom of the duct heated separately by high pressure steam.Two types of dryout were observed. For large quality region, the flow pattern is annular and the dryout occurs due to extinction of the annular liquid film. In this case, the difference between the top and the bottom is not remarkable. The other type of dryout occurs due to the defect of liquid at the top of the duct by phase separation. This phase separation is more liable to occur when the flow velocity is smaller and the duct height is larger. In this case, the critical heat flux at the top is significantly small as compared with that at the bottom.
- 一般社団法人日本機械学会の論文
著者
-
ISHIGAI Seikan
Faculty of Engineering, Osaka University
-
Kaji Masuo
Faculty Of Engineering Osaka University.
-
Kaji Masuo
Faculty Of Engineering Osaka University
-
Ishigai Seikan
Faculty Of Engineering Osaka University
-
Takagi Toshimi
Faculty Of Engineering Osaka University.
-
Takagi Toshimi
Faculty Of Engineering Osaka University
-
ICHIYAMA Shuichi
Hitachi Ltd.
関連論文
- Shell-Side Pressure Drop in the Multi-Baffled Shell-and-Tube Heat Exchangers
- Boiling Crisis in the Horizontal Channel : (4th Report, Analysis on Burnout Heat Flux in Annular Mist Flow)
- A Practical Calculation Method of Varying Pressure Steam Accumulators
- Measurement of the Component Flows in a Vertical Two-Phase Flow by Making Use of the Pressure Fluctuation : Part 2,The Flow Model for the Slug-Flow and Its Application
- Experimental Study of Structure of Gas Flow in Tube Banks with Tube Axes Normal to Flow Part II ; On the Structure of Gas Flow in Single-Column , Single-Row, and Double-Rows Tube Banks
- Measurement of the Component Flows in a Vertical Two-Phase Flow by Making Use of the Pressure Fluctuation : Part 1,Proposal of a Characteristic Number
- Boiling Crisis in the Horizontal Channel : 3rd Report, Burnout in Uniformly Heated Horizontal Tubes
- Boiling Crisis in the Horizontal Channel : 1st Report, Critical Heat Flux for Square Channel with Separately Heated Top or Bottom
- A Treament for Thermal Efficiency Improvement in the Brayton Cycle
- Experimental Study on Structure of Gas Flow in Tube Banks with Tube Axes Normal to Flow : Part 1, Karman Vortex Flow from Two Tubes at Various Spacings
- Experimental Study of Transition Boiling on a Vertical Wall in Open Vessel
- Flow Instabilities in Boiling Channels : Part 2 Geysering
- Flow Instabilities in Boiling Channels : Part 1 Pressure Drop Oscillation
- Fundamental Studies on NO and CO Emissions and Their Control in Combustion Systems : 2nd Report, Numerical Study on Various Factors Affecting NO Formation and Effectiveness of Emission Control Systems
- Fundamental Studies on NO and CO Emissions and Their Control in Combustion Systems : 1st Report, An Experiment Using Flat Flame Burner and Its Interpretation by Chemical Kinetics
- Experimental Studies of Disturbance Waves in Boiling Two-Phase Flow : Continued Report; Effects of Hydrodynamic Non-Equilibrium and Density Ratio : Series B : Fluid Engineering, Heat Transfer, Combustion, Power, Thermophysical Properties
- Ignition and Combustion of a Fine Fuel Droplet Falling Freely into the Hot Atmosphere
- Turbulent Transport of Momentum and Heat in a Swirling Flame : Retardation of Mixing and Counter-Gradient Diffusion
- Effects of Liquid Viscosity on Characteristics of Waves in Gas-Liquid Two-Phase Flow : Characteristics of Huge Waves and Disturbance Waves
- Flow Boiling in Tube of Mixtures of Refrigerants R-11 and R-113 : Series B : Fluid Engineering, Heat Transfer, Combustion, Power, Thermophysical, Properties
- On the Flashing Flow of Saturated Water Through Horizontal Pipes
- Heat Transfer of the Impinging Round Water Jet in the Interference Zone of Film Flow along the Wall