Flow in Annular Diffuser : 1st Report, Internal Flow and Performance
スポンサーリンク
概要
- 論文の詳細を見る
The internal flow and the performance of an annular diffuser composed of a cylindrical casing and a conical hub were examined experimentally. When the flow has no whirl component at the inlet, the optimum convergent angle of the hub, giving the best pressure recovery, is about 24 degrees. But with an increment of the whirl component, the component roughly changes to the free vortex pattern at the downstream passage independent of the initial flow pattern and the axial velocity is faster near the hub side than near the casing side. Accordingly, it is possible to prevent the separation by giving an adequate whirl component at the inlet, even if it occurs at the hub wall with a large convergent angle in the case without the whirl component. When the whirl component becomes stronger, a reverse flow occurs along the hub wall at the definite area ratio irrespective of the convergent angle.
- 一般社団法人日本機械学会の論文
著者
-
KUROKAWA Junichi
Faculty of Engineering, Yokohama National University
-
Toyokura Tomitaro
Faculty Of Engineering Yokohama National University
-
Kanemoto Toshiaki
Faculty Of Engineering Kyushu Institute Of Technology
-
Kurokawa Junichi
Faculty Of Engineering Yokohama National University
関連論文
- Smart Control of Axial Flow Pump Performance by Means of Counter-Rotation (Counter-Rotating Type and Performance)(Turbomachinery)
- Flow Characteristics around a Valve Plate Installed in a Duct : 2nd Report, Swing Type Valve Plate Installed in a Chamber
- Flow Characteristics around a Valve Plate Installed in a Duct : 1st Report, Swing Type Valve Plate Installed at a Duct Exit
- Performances of Vertical Diffusers for Air-water Mixture Flow
- Studies on the Improvement of High-Specific-Speed Pump Performance at Low Flow Rates
- Development of Intelligent Wind Turbine Generator with Tandem Wind Rotors and Double Rotational Armatures : 1st Report, Superior Operation of Tandem Wind Rotors
- The Boundary Layer on a Rotating Thin Blade
- Studies on Back-Flow Mechanism of Turbomachines : (Part 2,Back-Flow to the Suction Side of Mixed-Flow Impeller Blades)
- Studies on Back-Flow Mechanism of Turbomachines : Part 1,Back-Flow Mechanism to the Suction Side of Axial-Flow Impeller Blades
- Studies in Japan on Circular Cascades Composed of Thick Vanes
- Studies on the Characteristics of Axial-Flow Pumps : Part 4,Comparison between Theory and Experimental Results
- Studies on the Characteristics of Axial-Flow Pumps : Part 3,Flow before and behind Impellers of Several Different Types
- Studies on the Characteristics of Axial-Flow Pumps : Part 2,Analytical Method of Determining the Discharge-Theoretical Head Characteristics
- Flow in Annular Diffusers : 2nd Report, Flow Analysis and Effect of Inlet Boundary Layer Thickness
- Absolute Flow Near Impeller Inlet of Centrifugal Turbomachine
- Studies on the Characteristics of Axial-Flow Pumps : Part 6,Experimental Studies on the Hydraulic Losses
- Studies on the Characteristics of Axial-Flow Pumps : Part 1,General Tendencies of the Characteristics of Pumps
- Performance of Very Low Specific Speed Centrifugal Pumps with Circular Casing
- Studies on Circular Cascades for Return Channels of Centrifugal Turbomachinery : 2nd Report, Flow and Performance of Cascade
- Flows in Diffusers Interfered with Wake behind a Circular Cylinder
- Vortex phenomena in a Water Tank
- Interference between Boundary Layer Flow and Wake Flow
- Studies on Circular Cascades for Return Channels of Centrifugal Turbomachinery : 3rd Report, Discussion on Separated Flow
- Flow in Annular Diffuser : 1st Report, Internal Flow and Performance
- Studies on Circular Cascades for Return Channels of Centrifugal Turbomachinery : 1st Report, Inverse Method and Cascade Design
- Accelerated and Decelerated Flows in a Circular Pipe : 1st Report, Velocity Profile and Friction Coefficient
- Flow in a Narrow Gap Along an Enclosed Rotating disk with Through-Flow
- Prediction of Outlet Flow Characteristics of Centrifugal Impellers : 1st Report, Consideration of Velocity Distortion
- A New Device to Control Axial Thrust of Radial Flow Turbomachinery