Performances of Vertical Diffusers for Air-water Mixture Flow
スポンサーリンク
概要
- 論文の詳細を見る
Diffuser performances for the two-phase flow of air-water mixture have been scarcely studied, though those for the mono-phase flow have been examined and the optimum diffuser profile is given. The diffuser performance for the mixture flow may be affected not only by the channel profile but also by the inlet velocity of the diffuser. Thus, this study aims to make clear the efficiencies of vertical diffuser with rectangular cross-section and to obtain the desirable channel profile and the inlet velocity, for the air-water mixture flow. The efficiency deteriorates as the air-water mixture ratio increases, and the desirable inlet velocity exists for each mixture ratio and channel profile. The highest efficiency is obtained when the diffuser length-width ratio l/W is about 7 irrespective of the mixture ratio. At l/W ≒7, the optimum divergent angle and inlet velocity are also determined from this result.
- 一般社団法人日本機械学会の論文
著者
-
Kanemoto T
Kyushu Inst. Technology Kitakyushu Jpn
-
KANEMOTO Toshiaki
Faculty of Engineering, Kyushu Institute of Technology
-
KASHIWABARA Toshinori
Kochi National College of Technology
-
TOYOKURA Tomitaro
Yokohama National University
-
TOYOKURA Tomitaro
Faculty of Engineering, Yokohama National University
-
SUZUKI Kenichi
Fuji Electric Co., Lit.
-
Toyokura Tomitaro
Faculty Of Engineering Yokohama National University
-
Kanemoto Toshiaki
Faculty Of Engineering Kyushu Institute Of Technology
-
Toyokura T
Yokohama National Univ. Yokohama Jpn
-
Suzuki Kenichi
Fuji Electric Co. Lit.
関連論文
- Smart Control of Axial Flow Pump Performance by Means of Counter-Rotation (Counter-Rotating Type and Performance)(Turbomachinery)
- Unsteady Laminar Flow Along an Enclosed Rotating Disk : Fluids Engineering
- Performances of Vertical Diffusers for Air-water Mixture Flow
- Studies on the Improvement of High-Specific-Speed Pump Performance at Low Flow Rates
- Development of Intelligent Wind Turbine Generator with Tandem Wind Rotors and Double Rotational Armatures : 1st Report, Superior Operation of Tandem Wind Rotors
- Transient Flow Caused by a Rotationally Decelerated Disk Enclosed in a Housing
- The Boundary Layer on a Rotating Thin Blade
- Studies on Back-Flow Mechanism of Turbomachines : (Part 2,Back-Flow to the Suction Side of Mixed-Flow Impeller Blades)
- Three-dimensional Boundary Layer Flow on Rotating Blades
- Studies on Back-Flow Mechanism of Turbomachines : Part 1,Back-Flow Mechanism to the Suction Side of Axial-Flow Impeller Blades
- Studies in Japan on Circular Cascades Composed of Thick Vanes
- Studies on the Characteristics of Axial-Flow Pumps : Part 4,Comparison between Theory and Experimental Results
- Studies on the Characteristics of Axial-Flow Pumps : Part 3,Flow before and behind Impellers of Several Different Types
- Studies on the Characteristics of Axial-Flow Pumps : Part 2,Analytical Method of Determining the Discharge-Theoretical Head Characteristics
- Flow in Annular Diffusers : 2nd Report, Flow Analysis and Effect of Inlet Boundary Layer Thickness
- Absolute Flow Near Impeller Inlet of Centrifugal Turbomachine
- Studies on the Characteristics of Axial-Flow Pumps : Part 6,Experimental Studies on the Hydraulic Losses
- Studies on the Characteristics of Axial-Flow Pumps : Part 1,General Tendencies of the Characteristics of Pumps
- Analysis of the Boundary Layer on a Workless Rotating Thin Blade
- Studies on Circular Cascades for Return Channels of Centrifugal Turbomachinery : 2nd Report, Flow and Performance of Cascade
- Flows in Diffusers Interfered with Wake behind a Circular Cylinder
- Vortex phenomena in a Water Tank
- Interference between Boundary Layer Flow and Wake Flow
- Studies on Circular Cascades for Return Channels of Centrifugal Turbomachinery : 3rd Report, Discussion on Separated Flow
- Flow in Annular Diffuser : 1st Report, Internal Flow and Performance
- Studies on Circular Cascades for Return Channels of Centrifugal Turbomachinery : 1st Report, Inverse Method and Cascade Design