Experiments on the Conical Diffuser Performance with Asymmetric Uniform Shear Inlet Flow : The Case of Diffuser with Free Discharge
スポンサーリンク
概要
- 論文の詳細を見る
One of the important factors affecting the diffuser performance is the shape of the inlet velocity profile. In this report, the results of measurements on a conical diffuser having various asymmetric uniform shear inlet flows are presented. Velocity distributions and pressure distributions were measured for four cone angles of diffuser and four degrees of shear of inlet flow for each diffuser. The main results obtained are as follows. Diffuser performance is decreased with an increased shear of inlet flow, and the reduction rate is maximum for a diffuser which has nearly an optimum shape for a uniform inlet flow without shear. With an increase of the inlet shear, a fixed large back-flow forms on the wall of the lower velocity side in the diffuser. This results in a decrease in the pressure recovery in the diffuser and also causes an increase in the outlet energy loss. A diagram indicating an equivalent cone angle of diffuser corresponding to that of one which has an inlet uniform flow is produced for the inlet shear.
- 一般社団法人日本機械学会の論文
著者
-
NAKAMURA Ikuo
Department of Mechanical Engineering, Nagoya University
-
Ishikawa Katsuya
Department Of Mechanical Engineering Meijo University
-
Furuya Yoshimasa
Gifu Technical College
-
Nakamura Ikuo
Department Of Mechanical Engineering Nagoya University
-
Nakamura Ikuo
Department Of Applied Physics Faculty Of Engineering University Of Tokyo
-
ISHIKAWA Katsuya
Department of Mechanical Engineering, Meijo University
関連論文
- Diffusion in Turbulent Pipe Flow Using a Stochastic Model
- Stochastic Characteristics of a Point-Source Plume Diffusion Field around a Sphere
- Fractal Aspect of Iso-velocity Set in a Turbulent Boundary Layer
- On Conditional Statistics ofthe Diffusion Field of Matter by a Point Source Plume in Uniform Mean Shear Flow
- The Disturbance Effect of a Circular Cylinder on the Diffusion of Matter by a Plume from a Point Source in Grid-yenerat 4ed Turbulence : 2nd Report, Characteristics of the Fluctuating Concentration Field : Series B : Fluid Engineering, Heat Transfer, Comb
- The Disturbance Effect of a Circular Cylinder on the Diffusion of Matter by a Plume from a Point Source in Grid-generated Turbulence : 1st Report, Characteristics of Velocity and Mean Concentration Field : Series B : Fluid Engineering, Heat Transfer, Comb
- Diffusion of Matter from a Continuous Point Source in Uniform Mean Shear Flows : 2nd Report, Characteristics of Concentration Fluctuation Intensity
- On a Method of the Concentration Measurement by the Use of Light Absoption Law
- An Experimental Study of the Interaction between Grid-Generated Turbulence and a 2-Dimensional Bluff Body : Effect of the Shedding Vortices on the Upstream Turbulence
- Clinical and virological features of chronic hepatitis C carriers with normal alanine aminotransferase levels despite positive serum HCV-RNA after interferon therapy
- Transmission-Type X-Ray Phase Retarder Using Ge Crystal in Laue Diffraction Geometry
- A Very Low Level DC Current Amplifier Using Photocoupler Negative Feedback Circuit
- Structural Variation Around the Gene Encoding the a Subunit of Soybean β-Conglycinin and Correlation with the Expression of the α Subunit
- An Experiment on a Taylor Vortex Flow in a Gap with a Small Aspect Ratio : Bifurcation of Flows in a Symmetric System
- Experiments on a Two-Dimensional Impinging Jet on a Wedge : Turbulence Properties and the Energy Balance
- An Experiment on a Taylor Vortex Flow in a Gap with a Small Aspect Ratio (Instability of Taylor Vortex Flows)
- Experiments on a Two-dimensional Impinging Jets on a Wedge : Mean Flow Properties
- The Turbulent Shear Flow on a Rotating Cylinder in a Quiescent Fluid : Flow Visualization and the Scale of Lump of Eddies
- Experiments on Three-dimensional Mixing of a Wall Jet with a Turbulent Boundary Layer
- Conditional Sampling Measurements in the Developing Region of The 3-D Turbulent Jet from a Square Nozzle : Series B : Fluid Engineering Heat Transfer Combustion, Power Thermophysical Properties
- A Quantitative Evaluation of Neutron Penumbral Imaging with a Toroidal-Segment Aperture
- Restoration of innate host defense responses by oral supplementation of branched-chain amino acids in decompensated cirrhotic patients
- Accumulation of the Products of β-Conglycinin α'-Subunit Gene Constitutively Expressed in Seeds and Non-Seed Tissues of the Transgenic Petunia Plants
- Performance Chart and Optimum Geometries of Conical Diffusers with Uniform Inlet Flow and Tailpipe Discharge
- Performance Chart and Optimum Geometries of Conical Diffusers with Uniform Inlet Flow and Free Discharge
- Study on Dynamical Properties of Intermittent Phenomena in Turbulent Boundary Layer
- Experiments on the Conical Diffuser Performance with Asymmetric Uniform Shear Inlet Flow : Effect of Tailpipe Discharge
- Experiments on the Conical Diffuser Performance with Asymmetric Uniform Shear Inlet Flow : The Case of Diffuser with Free Discharge
- A Study on Flow Characteristics of Pulp Suspension : 2nd Report, Flocculation Measurements of a Thick Fiber Suspension
- Some Progress in the Research of the Dynamical Structure in Wall Turbulence
- Clarification of interspousal hepatitis C virus infection in acute hepatitis C patients by molecular evolutionary analyses : Consideration on sexual and non-sexual transmission between spouses