Flow Visualisation of Process of Producing Induction Swirl using a Water Model
スポンサーリンク
概要
- 論文の詳細を見る
This paper is concerned with an experimental investigation on the process of producing an induction swirl in a four cycle engine. A water model test based on dynamic similarity was executed using three kinds of intake valves connected with a directed port. In-cylinder flows during the intake stroke in the model were visualized by tracer particles. Two kinds of methods were adopted in their analysis . One is a technique using a movie camera and the other is simultaneous photography using a pair of still cameras. The main feature of the induction swirl was clarified by analysis of the traces. The results show that the intake valve geometry makes a difference in the induction swirl and the local swirl intensity of the cylinder.
- 一般社団法人日本機械学会の論文
著者
-
Hosokawa Tsutomu
Himeji Institute Of Technology
-
Hosokawa Tsutomu
Himeji Institute Of Technology Department Of Mechanical Engineering
-
KOMATSU Genichi
Himeji Institute of Technology, Department of Mechanical Engineering
-
SHlRAE Susumu
Toyodenkiseizo Co. Ltd.
-
Komatsu Genichi
Himeji Institute Of Technology Department Of Mechanical Engineering
-
Komatsu Genichi
Himeji Institute of Technology
関連論文
- Numerical Simulation of Air Motion in the Swirl Chamber of a Diesel Engine : Effect of Connecting Port in Air Motion
- Flow Visualisation of Process of Producing Induction Swirl using a Water Model
- Behavior of a Water Drop on a Horizontal Unwet Tube : Series B : Fluid Engineering Heat Transfer Combustion, Power Thermophysical Properties
- B307 HEAT TRANSFER CHARACTERISTIC ON VERTICAL CIRCULAR TUBE UNDER DROPWISE CONDENSATION : Effect of the direction of cooling water on the heat transfer
- Dropwise Condensation Heat Transfer on a Horizontal Tube