Short Pipes Climbing up a Vibrating Vertical Rod
スポンサーリンク
概要
- 論文の詳細を見る
Under some conditions a short pipe with a tapered square hole, which is called an oscillator. can rise along a vertically erected vibrating square rod. Behaviours of oscillators are investigated theoretically and experimentally. Geometrical amount of rise of an oscillator per a cycle depends on its taper angle and hole width. Amount of fall of the oscillator depends on the clearance and the friction factor between the oscillator and the rod. radius of gyration of the oscillator and the magnitude an the frequency of the vibration of the rod. Real rise of the oscillator is equal to the difference between the two amounts.
- 一般社団法人日本機械学会の論文
著者
-
Kiyono Satoshi
Faculty Of Engineering Tohoku University
-
Sakai Takao
Faculty Of Engineering Yamagata University
-
Sakai Takao
Faculty Of Engineering. Tohoku University
-
Kiyono Satoshi
Faculty Of Engineering. Tohoku University
-
Kiyono Satoshi
Faculty Of Engineering Tohoku Univ.
関連論文
- A Study on Zero-backlash Reduction Mechanism
- Simplified Stepping Motors Driven by Yawing Motion (1st Report The Principle of a Yawing Motor) : Series C : Vibration, Control Engineering, Engineering for Industry
- Simplified Stepping Motor Driven by Yawing Motion : 2nd report Improvement of Contacting Mechanism : Series C : Vibration, Control Engineering, Engineering for Industry
- A Simple and Effective Error Separation Method for Roundness Measurement
- A Method of NC Gear Cutting with Simply Shaped Tool : Application to Worm Wheel Cutting : Series C : Vibration, Control Engineering, Engineering for Industry
- A Simple Method of Bevel Gear Cutting : 2nd Report, Crowning Method
- A Simple Method of Bevel Gear Cutting : 1st Report, The Basic Conception of the Cutting Method
- Analysis of Vibration of Bevel Gears
- A Study on NC Gear Cutting of Large-size Bevel Gears : 3rd Report; A Method to Save Path Number of the Cutter in Tooth Generation
- A Study on NC Gear Cutting of Large-size Bevel Gears : 2nd Report; End-milling for the Taper Tooth
- A Study on NC Gear Cutting of Large-size Bevel Gears : 1st Report: Cutting by End Milling
- A Method for Fast Estimation of the Vibration of Spur Gears : Series C : Vibration, Control Engineering, Engineering for Industry
- Short Pipes Climbing up a Vibrating Vertical Rod
- Comparison of Optical Position Detectors in a Force Controlled Displacement Probe
- Self-Zero-Adjustment of Probes in the Methods Constructing Software Datum for Large Profile Measurement
- An angle-based position detection method for precision machines