造塊用粘土質耐火煉瓦の諸性質と熱的スポーリング抵抗性に関する考察 : 造塊用耐火物に関する研究(第2報)
スポンサーリンク
概要
- 論文の詳細を見る
For the purpose of investigating the effective way of preventing the thermal fracture of various bricks for bottom casting pit in teeming of molten steel, the equation of thermal shock resistance has been deduced from thermal stress equation, and the physical-mechanlcal properties of various bricks have been determined by testing. On the basis of the results obtained, considerations have been made concerning the effect of these properties and the size of each brick on thermal shock resistance.Important results obtained are summarized as follows:i) In the thermal stress equation σ=Eα/(1-μ)⋅(θ0-Θ)⋅f, thermal shock resistance (R) are expressed in σmax/σ′, putting σ′ as max. thermal stress in tension, f′ as factor f corresponding to σ′, σmax as max. tensile strength of a brick.ii) Heat-transfer coefficient from molten steel flowing at temperature θ0 to the surface of the brick at temperature Θ being in contact with molten steel flow is very large, and therefore, thermal shock resistance is expressed by the following two equations.In the earliest stage, when heat doesnt begin to flow within a brick:R2′=σmax/E⋅(1-μ)/α⋅1/(θ0-Θ)In the next stage, when heat flows within a brick:R1′=σmax/E⋅(1-μ)/α⋅1/(θ0-Θ)⋅(kt1/2/γ)aor R1′=σmax/E⋅(1-μ)/α⋅1/(θ0-Θ)⋅(K/γh)a′iii) The relation between the mechanical properties and porosity may be expressed by a hyperbolic curve.iv) The ratio of bending strength to Youngs modulus, an effective factor for increasing thermal shock resistance, is larger in pyrophillite-clay brick than that in grog-clay brick. This ratio shows a trend to decrease with increasing porosity. It is presumed from the data in technical literatures that this ratio is approximately constant at high temperature below the critical temperature of pyroplastic property.v) Based on the equation of thermal shock resistance determined in the case of runner brick, it is estimated that bending strength/Youngs modulus ratio, linear thermal-expansion coefficient (α), poissons ratio (μ) and temperature difference (θ0-Θ) have an influence of first power. On the other hand, the thermal conductivity (K), specific heat (Cρ), density (ρ) and wall thickness (γ) have an infiuence of 0.040 and 0.081 powers, respectively, on thermal shock resistance. In addition, considerations have been made concerning the degree of the effect of porosity, which is in functional relation to mechanical properties and thermal conductivity, on the thermal shock resistance.vi) It is presumed that there is a limit in the improvement of thermal shock resistance by changing the properties of a fire clay brick and that most important factor for the prevention of thermal fracture is the moderate pyroplastic property.
- 1960-12-01
著者
関連論文
- 鉄鉱石の酸化度, 還元率及び被還元性に就て
- 鐵鑛石の被還元性に就て
- 48 鐵鑛石の酸化度, 還元率及び被還元性に就て(日本鐵鋼協會第 44 回講演大會講演大要)
- 釜石及び高の倉兩鐵鑛石の酸化焙焼に關する研究
- 合成 Fayalite に關する研究
- 75. 釜石及び高の倉兩磁鐵鑛の酸化焙燒に關する研究
- 炭素鋼壓延材の高温酸化に關する研究 (I)
- 造塊用粘土質耐火煉瓦の諸性質と熱的スポーリング抵抗性に関する考察 : 造塊用耐火物に関する研究(第2報)
- 熔鋼による下注用煉瓦の熔蝕機構, 並びに高アルミナ質砂の発生原因について : 造塊用粘土質耐火物に関する研究(第5報)
- 下注用粘土質煉瓦の熔蝕状態, 並びにスカム, 酸化物系非金属介在物についての試験調査 : 造塊用粘土質耐火物に関する研究(第4報)
- 注入熔鋼の流れ状態に影響をおよぼす耐火物設計上の1,2の問題 : 造塊用粘土質耐火物に関する研究(第3報)
- 注入時における下注用各煉瓦の破壊原因について : 造塊用粘土質耐火物に関する研究(第1報)
- 塩基製平炉用クロム-マグネシア耐火物とスピネル (2)
- 塩基性平炉用クロム-マグネシア耐火物とスビネル (1)
- 文献より見た造塊用耐火物の材質, 設計ならびに熔蝕 (1)
- 炭素鋼壓延材の高温酸化に關する研究 (II) : 燒減り量並びに高温酸化及びスケール・オフの深さの關係
- 各地産鐵鑛石の組織及び性質に就て
- 1 造塊用耐火物の熔蝕に就ての一考察(日本鐵鋼協會第 46 囘講演大會講演大要)
- 44 造塊用粘土質煉瓦の二, 三の物理的性質(日本鐵鋼協會第 44 回講演大會講演大要)
- 製鐵用石炭の灰分について
- 諏訪鐵鑛石に關する研究 (II) : 附群馬鐵鑛石
- 諏訪鐵鑛石に關する研究 (1)
- 加熱爐築造上の指針
- 文献より見た造塊熔耐火物の材, 設計並びに熔蝕 (3)
- 文献より見た造塊用耐火物の材質, 設計並びに熔蝕 (2)