X線による塑性疲労に関する研究(塑性疲労過程における試験片表面層と内部での微視的組織の相違)

概要

論文の詳細を見る
From several reports of scientific experiments that have been recorded in the literature of science it appears that the practice of removing layer after layer of the specimen surface during the low-cycle fatigue testing has an effect of lengthening the fatigue life. and it is surmised as possible that this phenomenon is due to some microstructural difference that is created by cyclic straining between the surface and the inside of the specimen. And detecting of this structural difference would provide more resources to the study on low-cycle fatigue behavior. From this point of view, authors applied the X-ray diffraction techniques to observation of the microstructural change in surface and the inside of the specimen during constant strain-cycling. The following facts have been revealed as the result of this investigation : (1) It is revealed by the X-ray microbeam diffraction technique that there is subgrain formation development not only on the surface layer but also inside the specimen in the process of low-cycle fatigue before visible cracks occur. (2) The period of the low-cycle fatigue process from distribution of the integral breadth of its X-ray diffraction peaks from the surface in the direction of depth to the occurrence of visible cracks is devided into two stages. The first stage marks larger increase. with increase in the number of in cycling, in the integral breadth on the surface of the specimen than inside. During the second stage the integral breadth tends to decrease on the surface of the specimen, but keeps increasing inside. The integral breadth shows smaller value on the surface than inside around the failure point. (3) Microscopic cracks are found to occur toward the end of the first stage, and develop in direction of depth from the surface during the second stage. (4) The average value of integral breadth obtained from inside the specimen has a linear relation with the stress range during the low-cycle fatigue before fracture.
社団法人日本材料学会の論文
1969-12-15

X線による塑性疲労に関する研究(塑性疲労過程における試験片表面層と内部での微視的組織の相違)

スポンサーリンク

概要

著者

関連論文

スポンサーリンク