A Model of Electro-Spraying Mechanism

スポンサーリンク

概要

• 論文の詳細を見る

• One model to the mechanism of electro-spraying is proposed as the following; a droplet with constant radius falls out from a capillary by electric repulsion against surface tension, and the droplet breaks up into many small particles in accordance with the transition from the excited level to the ground level. To make sure of this model electro-spraying of several dielectric solutions was done by using simple experimental equipment. Especially the spread of the small particles and their density distribution were examined newly. These results and a few results obtained before by other experimentalists agree fairly good with the approximate values to be calculated by this model.

• 社団法人日本物理学会の論文
• 1969-10-05

著者

• MIYAHARA Hiroshi

  Department of Radiological Technology, School of Health Sciences, Nagoya University

• Miyahara Hiroshi

  Department Of Nuclear Engineering Faculty Of Engineering Nagoya University

関連論文

• Production of ^Eu for Gamma-Ray Emission Probability Measurement
• Development of Two-dimensional Data-acquisition Apparatus Using 8 mm Data Cartridge for 4πβ-γ Coincidence Measurement
• Highly Precise Measurement of the Relative Gamma-ray Detection Efficiency Curve
• Precise Measurement of Gamma-Ray Emission Probabilities for ^W by Using a Two-Dimensional 4πβ-γCoincidence System
• Characteristics and Correction of the Fading of Imaging Plate
• Precise Measurement of the Gamma-ray Emission Probabilities for ^In with Half-life of 54. 15 min
• Disintegration rate measurement of ^Pr
• GM-18 CONSOLIDATION OF SURFACE LAYER OF P/M GEARS BY FINISH ROLLING WITH SCREW-SHAPED TOOL(GEAR MANUFACTURING)
• A Model of Electro-Spraying Mechanism

スポンサーリンク