CFD Analysis of Sag Line Formation on the Zinc-coated Steel Strip after the Gas-jet Wiping in the Continuous Hot-dip Galvanizing Process

スポンサーリンク

概要

• 論文の詳細を見る

• One of the surface defects on the steel strip surface after the gas-jet wiping employing an air-knife system in the continuous hot-dip galvanizing process is called sag lines or snaky coating. The sag line defect is the oblique patterns such as “W”, “V” or “X” on the coated surface. The present paper presents an analysis of the sag line formation and a numerical simulation of sag lines by using the numerical data produced by Large Eddy Simulation (LES) of the three-dimensional compressible turbulent flow field around the air-knife system.In order to simulate the sag line formation, a novel perturbation model has been developed to predict the variation of coating thickness along the transverse direction. The thickness obtained by the proposed model yields very similar results with those obtained by the conventional equation. It is observed that the coating thickness along the transverse direction is affected more by the pressure gradient than the surface shear stress in the stagnation region, while in the far field the shear stress becomes the major factor to determine the thickness.Finally, the three-dimensional coating surface was obtained by the present perturbation model. It was found that the sag line formation is determined by the combination of the instantaneous coating thickness distribution along the transverse direction near the stagnation line and the feed speed of the steel strip. The computed mean distance between the crests and the shape of the simulated sag show relatively good resemblance with the real sag lines on the strip surface.

• 2011-01-15

著者

• So Hongyun

  Department of Mechanical Engineering, Korea Advanced Institute of Science and Technology (KAIST)

• Yoon Hyun

  Korea Atomic Energy Research Institute (KAERI)

• Chung Myung

  Department Of Environmental Science Sun Moon University

• Yoon Hyun

  Korea Advanced Institute Of Science And Technology (kaist)

• So Hongyun

  Department Of Mechanical Engineering Kaist

• CHUNG Myung

  Department of Mechanical Engineering, KAIST

関連論文

• CFD Analysis of Sag Line Formation on the Zinc-coated Steel Strip after the Gas-jet Wiping in the Continuous Hot-dip Galvanizing Process
• Development of an in vitro Environmental Monitoring System by Using Immune Cells
• Two-Dimensional Slow Viscous Flow Past a Plate Midway between an Infinite Channel
• Numerical Analysis of Edge Over-coating in Continuous Hot-dip Galvanizing
• 固気二相流に対する二流体乱流モデル
• 二次のクロージャモデルによる熱拡散乱流の数値シミュレーション
• Aerodynamic Investigation about the Cause of Check-mark Stain on the Galvanized Steel Surface
• Organ Distribution of Heavy Metals in Autopsy Material from Normal Korean
• A Noble Gas Wiping System to Prevent the Edge Overcoating in Continuous Hot-dip Galvanizing
• Development of Novel Air-knife System to Prevent Check-mark Stain on Galvanized Strip Surface
• CFD Analysis of Sag Line Formation on the Zinc-coated Steel Strip after the Gas-jet Wiping in the Continuous Hot-dip Galvanizing Process
• An analytical model of velocity-derivative skewness of rotating homogeneous turbulence
• Numerical Verification of the Performance of Double Jet Air-knife System in Avoiding the Check-mark Stain on the Zinc Coated Surface
• Cryogenic Heat-Exchanger Design for Freeze-out Removal of Carbon Dioxide from Landfill Gas
• A Two-Fluid Turbulence Model for Gas-Solid Two-Phase Flows.

もっと見る 閉じる

スポンサーリンク