Reaction behavior of Formed Iron Coke and Its Effect on Decreasing Thermal Reserve Zone Temperature in Blast Furnace
スポンサーリンク
概要
- 論文の詳細を見る
Usage of highly reactive coke in order to decrease the thermal reserve zone temperature in blast furnaces is promising to increase reaction efficiency in blast furnaces and to decrease the reducing agent rate. We focused on the catalytic effect of iron and succeeded in producing highly reactive formed iron coke with high iron content. In this paper the reaction behavior of formed iron coke when mixed with conventional coke and in the presence of alkali was investigated and the following results were obtained. When the mixture of iron coke and conventional coke is heated in a reaction gas, iron coke selectively and preferentially reacts near the thermal reserve zone temperature (900°C), which causes a decrease in the thermal reserve zone temperature, while conventional coke barely reacts and is protected from degradation. It was also confirmed that the catalytic activity of Fe and that of K is independent of each other and that in the presence of alkali, the reaction beginning temperature of iron coke is lower than that of conventional coke. These results show that the use of formed iron coke could decrease the thermal reserve zone temperature in an actual blast furnace where coke reactivity is promoted by condensed alkali vapor.
- 社団法人 日本鉄鋼協会の論文
- 2010-10-15
著者
-
Naito M
Environment & Process Technology Center Nippon Steel Corporation
-
Nomura Seiji
Nippon Steel Corporation Environment & Process Technology Center
-
KUNITOMO Kazuya
Engineering Research Center, Nippon Steel Corporation
-
Higuchi Kenichi
Nippon Steel Corporation Environment & Process Technology Center
-
Naito Masaaki
Nippon Steel Corporation Environment & Process Technology Center
-
KUNITOMO Kazuya
Nippon Steel Corporation, Environment & Process Technology Center
-
Kunitomo Kazuya
Engineering Research Center Nippon Steel Corporation
-
Nomura Seiji
Nippon Steel Corp. Environment & Process Technol. Center
関連論文
- Non-spherical Carbon Composite Agglomerates : Lab-scale Manufacture and Quality Assessment
- Optimization of Chemical Composition and Microstructure of Iron Ore Sinter for Low-temperature Drip of Molten Iron with High Permeability
- Blast Furnace Ironmaking System Using Partially Reduced Iron Ore Reduced by an Energy Source with Low Carbon Content
- Reaction Behavior of Dolomite Accompanied with Formation of Magnetite Solid Solution in Iron Ore Sintering Process
- The Characteristics of Catalyst-coated Highly Reactive Coke
- Improvement in Blast Furnace Reaction Efficiency through the Use of Highly Reactive Calcium Rich Coke
- Analysis of Traveling Behavior of Nut Coke Particles in Bell-type Charging Process of Blast Furnace by Using Discrete Element Method
- Effect of Chute Angle on Charging Behavior of Sintered Ore Particles at Bell-less Type Charging System of Blast Furnace by Discrete Element Method
- Validation of Particle Size Segregation of Sintered Ore during Flowing through Laboratory-scale Chute by Discrete Element Method
- Post-reaction Strength of Catalyst-added Highly Reactive Coke
- Large Scale Simulation of Coke and Iron Ore Particle Motions and Air Flow in Actual Blast Furnace
- Reaction behavior of Formed Iron Coke and Its Effect on Decreasing Thermal Reserve Zone Temperature in Blast Furnace
- Coking Pressure Control by Selective Crushing of High Coking Pressure Coal
- Decrease in Carbon Consumption of a Commercial Blast Furnace by Using Carbon Composite Iron Ore