A Proposal for Evaluation Method of Energy Parameter Values in Cell Model for Thermodynamics of Refining Slag
スポンサーリンク
概要
- 論文の詳細を見る
In the cell model, a thermodynamic model of slag, the fractions of heterogeneous cation pairs are calculated which compose cells with an oxygen atom in between by the minimization of free energy of slag with energy parameters. On the other hand, by using NMR the fractions can be measured. Therefore, a new method can be proposed to evaluate the energy parameter values used in the cell model so that the calculated fractions in the slag with its minimum of free energy coincide with the measurement. The possibility of this evaluation method of energy parameter values was examined by the comparison of bridging oxygen/non-bridging oxygen (BO/NBO) ratio calculated by the cell model with energy parameter assessed elsewhere with measured BO/NBO ratio by NMR. The BO/NBO ratios of three SiO2–Al2O3–CaO slags with different basicities calculated by the use of cell model with energy parameter values assessed elsewhere were 42.5/57.5, 45/55 and 70/30, respectively. On the other hand, from 17OMAS spectrum and 27Al→17O CP/MAS spectrum of the same slags fully labeled and calcinated at 1600 centigrade degree, the ratios of BO/NBO in the slags were determined as 48.5/51.5, 42/58 and 76/24, respectively. This agreement supports the energy parameter values assessed elsewhere and gives a good expectation to the proposed method.
- 社団法人 日本鉄鋼協会の論文
- 2007-06-15
著者
-
Saito Koji
Advanced Technology Research Laboratories Nippon Steel Corporation
-
Shimoda Keiji
Advanced Technology Research Laboratories Nippon Steel Corporation
-
Yamada Wataru
Kimitsu R&d Lab. Nippon Steel Corp.
-
Yamada Wataru
Kimitsu R&d Lab Technical Development Bureau Nippon Steel Corp.
-
Yamada Wataru
Kimitsu R&d Laboratory Nippon Steel Corporation
-
Kanehashi Koji
Advanced Technology Research Laboratories Nippon Steel Corporation
-
MATSUMIYA Tooru
Technical Development Bureau
-
Matsumiya Tooru
Technical Development Bureau Nippon Steel Corporation
-
Yamada Wataru
Kimitsu R & D Laboratory Nippon Steel Corporation
-
Saito Koji
Advanced Technol. Laboratories
関連論文
- Recent Topics of Research and Development in Continuous Casting
- Magic-angle-spinning NMR at 30T with a Hybrid Magnet
- ^P{^Al} MQMAS/HETCOR NMR Study on Structure of Amorphous AlPO_4
- Cold Model Experiment on Infiltration of Mould Flux in Continuous Casting of Steel : Simulation of Mould Oscillation
- Cold Model Experiment on Infiltration of Mould Flux in Continuous Casting of Steel : Simple Analysis Neglecting Mould Oscillation
- The Mode of Substrate-Recognition Mechanism of Arylmalonate Decarboxylase
- Direct Observation of Thiol Ester Formation between an Enzyme and an Active Site Directed Inhibitor by FT-IR
- Electromagnetic Casting for High Quality of Continuously Cast Steel
- Nucleation of the Primary Al Phase on TiAl_3 during Solidification in Hot-Dip Zn-11%Al-3%Mg-0.2%Si-Coated Steel Sheet
- Solidification Structure of the Coating Layer on Hot-Dip Zn-11%Al-3%Mg-0.2%Si-Coated Steel Sheet
- Detailed Structure Elucidation of the Blast Furnace Slag by Molecular Dynamics Simulation
- Ultra-high Magnetic Field (21.8T) Solid-state Nuclear Magnetic Resonance for Inorganic Materials
- The Application of Infrared Spectrophotometry to Analysis of Dehydration Process of Inorganic Hydroxides and Evaluation of Monolithic Refractories
- A Proposal for Evaluation Method of Energy Parameter Values in Cell Model for Thermodynamics of Refining Slag
- Local Environments of Slags : The First Application of ^Ca 3QMAS NMR Technique
- Natural Abundance Solid-state ^Mg MQMAS NMR Studies on Inorganic Solids at a High Magnetic Field of 16.4T
- Mechanism of a Hydrogen-induced Sticker Breakout in Continuous Casting of Steel : Influence of Hydroxyl Ions in Mould Flux on Heat Transfer and Lubrication in the Continuous Casting Mould
- Structural Analysis of Boron Carbide Using 2D ^B-MQMAS NMR
- Development of Thermodynamic Model for Steelmaking Slags and Its Application to Analyses of Steelmaking Process
- Ostwald growth of Fe_3C and Distributions of Carbon Atoms in α-iron Annealed Under a Constant Temperature Gradient
- Mathematical Modelling of Change in Composition of Mold Flux in Continuous Casting of Steels
- Infiltration Phenomena of Molten Powder in Continuous Casting Derived from Analysis Using Reynolds Equation Part 2 : Unsteady Analysis
- Infiltration Phenomena of Molten Powder in Continuous Casting Derived from Analysis Using Reynolds Equation Part 1 : Steady Analysis
- Structural Study on Amorphous AIPO_4 by ^O MQMAS and Mutual (^P 【tautomer】 ^O) CP/MAS NMR
- Influence of Si Addition to the Coating Bath on the Growth of the Al-Fe Alloy Layer in Hot-dip Zn-Al-Mg Alloy-coated Steel Sheets